Frigidaire Wine Coolers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
dF
Display shows dF or DF and unit may pause cooling periodically.
Defrost Mode Indication / Defrost Cycle Active
E1
Wine cooler beeps and displays E1, unit not cooling or only slightly cool.
Cabinet Temperature Sensor (Thermistor) Failure
E2
Wine cooler displays E2 and may run continuously or not cool correctly.
Evaporator Temperature Sensor Failure
E3
Wine cooler shows E3 and interior temperature is inaccurate or fluctuates widely.
Ambient (Room) Temperature Sensor Failure
E4
Wine cooler displays E4 and may shut down cooling or run erratically.
Defrost Sensor or Defrost Circuit Fault (for frost-free Frigidaire wine cellars)
E5
Wine cooler shows E5 and compressor or fans may not start or may short-cycle.
Compressor Start/Overload or Power Supply Fault
E6
Wine cooler displays E6 and the control panel may be unresponsive or partially functional.
User Interface / Control Panel Communication Error
E7
Wine cooler shows E7 and interior lights or fans may behave erratically.
Main Control Board Failure or Firmware Error
E8
Wine cooler displays E8 and the fan may not run or runs at incorrect speed.
Evaporator Fan Motor or Fan Feedback Error
E9
Wine cooler shows E9 and interior temperature cannot be adjusted or remains at one extreme.
Dual-Zone Communication or Damper Control Error (for dual-zone Frigidaire wine coolers)
ER
Display shows ER or Err and controls may not respond properly.
General Control Error / Keypad Fault
H1
Display shows H1 and the cabinet is very warm; cooling may be disabled.
High Temperature Alarm Condition
Hi
Display shows Hi or flashes Hi; audible alarm may sound and interior is warm.
High Temperature Alarm / Over-Temperature Condition
L1
Display shows L1 and interior temperature is very low; bottles may be over-chilled.
Low Temperature Alarm / Thermostat Control Fault
Lo
Display shows Lo or flashes Lo when adjusting temperature; unit may not cool further.
Setpoint Below Minimum / Low Temperature Limit Reached
Symptom
Alarm beeps periodically even though temperature appears normal.
Faulty Door or Temperature Alarm Circuit
Symptom
Buttons on the control panel do not respond or respond intermittently.
Keypad / User Interface Failure
Symptom
Clicking noise every few minutes; compressor tries to start but shuts off.
Compressor Overload Tripping
Symptom
Condensation or moisture on the inside of the glass door.
High Humidity or Door Seal Issue
Symptom
Display is dim, flickering, or segments are missing, but cooling is normal.
Display Module or UI Power Issue
Symptom
Display shows temperature, but actual interior temperature is significantly different.
Temperature Sensing or Calibration Error
Symptom
Door does not close or seal properly; door pops open slightly after closing.
Door Alignment or Gasket Deformation
Symptom
Door gasket is torn or hardened, causing air leaks and poor cooling.
Door Gasket Deterioration
Symptom
Excessive frost or ice buildup on the back wall or around bottles.
Air Infiltration or Defrost System Issue
Symptom
Exterior of the wine cooler cabinet feels hot, especially around the door frame.
Normal Condenser Loop Heating or Overheating Due to Poor Ventilation
Symptom
Interior light stays on even when the door is closed, causing overheating.
Stuck Door Switch or Control Logic Fault
Symptom
Musty or moldy odor inside the wine cooler.
Microbial Growth on Interior Surfaces or Drain Pan
Symptom
Strong chemical or burning smell coming from the wine cooler.
Electrical Overheating or Insulation Odor
Symptom
Unit vibrates excessively and may move or rattle against cabinets.
Improper Leveling or Loose Internal Components
Symptom
Water pooling at the bottom of the wine cooler or on the floor in front.
Condensate Drain Blockage or Excess Condensation
Symptom
Wine cooler interior is too cold; wine is over-chilled or partially frozen.
Thermostat / Temperature Control Miscalibration
Symptom
Wine cooler interior light does not work, but cooling is normal.
LED Light Assembly or Door Switch Failure
Symptom
Wine cooler lights and display work, but compressor and fans never start.
Control Board Output Failure or Incorrect Mode
Symptom
Wine cooler makes a grinding or scraping noise from inside the cabinet.
Evaporator Fan Blade Hitting Ice or Obstruction
Symptom
Wine cooler makes loud humming or buzzing noise during operation.
Compressor or Fan Vibration Noise
Symptom
Wine cooler not cooling and compressor never starts; display may be lit.
Compressor Start Device or Overload Failure
Symptom
Wine cooler runs but does not cool; interior stays at room temperature.
Sealed System Failure (Refrigerant Leak or Compressor Fault)
Symptom
Wine cooler runs constantly and is too warm inside.
Poor Condenser Airflow or Dirty Condenser Coils
Symptom
Wine cooler will not power on; display is blank and no lights or sounds.
No Power / Power Supply Failure
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| dF |
Display shows dF or DF and unit may pause cooling periodically.
|
Defrost Mode Indication / Defrost Cycle Active | View Details |
| E1 |
Wine cooler beeps and displays E1, unit not cooling or only slightly cool.
|
Cabinet Temperature Sensor (Thermistor) Failure | View Details |
| E2 |
Wine cooler displays E2 and may run continuously or not cool correctly.
|
Evaporator Temperature Sensor Failure | View Details |
| E3 |
Wine cooler shows E3 and interior temperature is inaccurate or fluctuates widely.
|
Ambient (Room) Temperature Sensor Failure | View Details |
| E4 |
Wine cooler displays E4 and may shut down cooling or run erratically.
|
Defrost Sensor or Defrost Circuit Fault (for frost-free Frigidaire wine cellars) | View Details |
| E5 |
Wine cooler shows E5 and compressor or fans may not start or may short-cycle.
|
Compressor Start/Overload or Power Supply Fault | View Details |
| E6 |
Wine cooler displays E6 and the control panel may be unresponsive or partially functional.
|
User Interface / Control Panel Communication Error | View Details |
| E7 |
Wine cooler shows E7 and interior lights or fans may behave erratically.
|
Main Control Board Failure or Firmware Error | View Details |
| E8 |
Wine cooler displays E8 and the fan may not run or runs at incorrect speed.
|
Evaporator Fan Motor or Fan Feedback Error | View Details |
| E9 |
Wine cooler shows E9 and interior temperature cannot be adjusted or remains at one extreme.
|
Dual-Zone Communication or Damper Control Error (for dual-zone Frigidaire wine coolers) | View Details |
| ER |
Display shows ER or Err and controls may not respond properly.
|
General Control Error / Keypad Fault | View Details |
| H1 |
Display shows H1 and the cabinet is very warm; cooling may be disabled.
|
High Temperature Alarm Condition | View Details |
| Hi |
Display shows Hi or flashes Hi; audible alarm may sound and interior is warm.
|
High Temperature Alarm / Over-Temperature Condition | View Details |
| L1 |
Display shows L1 and interior temperature is very low; bottles may be over-chilled.
|
Low Temperature Alarm / Thermostat Control Fault | View Details |
| Lo |
Display shows Lo or flashes Lo when adjusting temperature; unit may not cool further.
|
Setpoint Below Minimum / Low Temperature Limit Reached | View Details |
| – |
Alarm beeps periodically even though temperature appears normal.
|
Faulty Door or Temperature Alarm Circuit | View Details |
| – |
Buttons on the control panel do not respond or respond intermittently.
|
Keypad / User Interface Failure | View Details |
| – |
Clicking noise every few minutes; compressor tries to start but shuts off.
|
Compressor Overload Tripping | View Details |
| – |
Condensation or moisture on the inside of the glass door.
|
High Humidity or Door Seal Issue | View Details |
| – |
Display is dim, flickering, or segments are missing, but cooling is normal.
|
Display Module or UI Power Issue | View Details |
| – |
Display shows temperature, but actual interior temperature is significantly different.
|
Temperature Sensing or Calibration Error | View Details |
| – |
Door does not close or seal properly; door pops open slightly after closing.
|
Door Alignment or Gasket Deformation | View Details |
| – |
Door gasket is torn or hardened, causing air leaks and poor cooling.
|
Door Gasket Deterioration | View Details |
| – |
Excessive frost or ice buildup on the back wall or around bottles.
|
Air Infiltration or Defrost System Issue | View Details |
| – |
Exterior of the wine cooler cabinet feels hot, especially around the door frame.
|
Normal Condenser Loop Heating or Overheating Due to Poor Ventilation | View Details |
| – |
Interior light stays on even when the door is closed, causing overheating.
|
Stuck Door Switch or Control Logic Fault | View Details |
| – |
Musty or moldy odor inside the wine cooler.
|
Microbial Growth on Interior Surfaces or Drain Pan | View Details |
| – |
Strong chemical or burning smell coming from the wine cooler.
|
Electrical Overheating or Insulation Odor | View Details |
| – |
Unit vibrates excessively and may move or rattle against cabinets.
|
Improper Leveling or Loose Internal Components | View Details |
| – |
Water pooling at the bottom of the wine cooler or on the floor in front.
|
Condensate Drain Blockage or Excess Condensation | View Details |
| – |
Wine cooler interior is too cold; wine is over-chilled or partially frozen.
|
Thermostat / Temperature Control Miscalibration | View Details |
| – |
Wine cooler interior light does not work, but cooling is normal.
|
LED Light Assembly or Door Switch Failure | View Details |
| – |
Wine cooler lights and display work, but compressor and fans never start.
|
Control Board Output Failure or Incorrect Mode | View Details |
| – |
Wine cooler makes a grinding or scraping noise from inside the cabinet.
|
Evaporator Fan Blade Hitting Ice or Obstruction | View Details |
| – |
Wine cooler makes loud humming or buzzing noise during operation.
|
Compressor or Fan Vibration Noise | View Details |
| – |
Wine cooler not cooling and compressor never starts; display may be lit.
|
Compressor Start Device or Overload Failure | View Details |
| – |
Wine cooler runs but does not cool; interior stays at room temperature.
|
Sealed System Failure (Refrigerant Leak or Compressor Fault) | View Details |
| – |
Wine cooler runs constantly and is too warm inside.
|
Poor Condenser Airflow or Dirty Condenser Coils | View Details |
| – |
Wine cooler will not power on; display is blank and no lights or sounds.
|
No Power / Power Supply Failure | View Details |
No matching codes found
Advertisements