Farberware Coffee Makers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Display shows E1 and brewing will not start or stops immediately after pressing the brew button.
Water Reservoir Presence/Position Error
E2
Display shows E2 and the coffee maker will not heat or brew.
Overheat / Thermal Cutoff Protection Triggered
E3
Display shows E3 and brewing stops mid-cycle or never starts heating.
Temperature Sensor (NTC) Fault
E4
Display shows E4 and the coffee maker beeps without starting the brew cycle.
Water Flow / Pump Error
E5
Display shows E5 and the unit will not brew; sometimes accompanied by a lid or basket icon.
Brew Basket / Lid Not Closed Detection Error
E6
Display shows E6 and the clock or control panel becomes unresponsive.
Control Panel / Keypad Communication Error
E7
Display shows E7 and the unit shuts off shortly after starting a brew cycle.
Power Supply / Voltage Error
E8
Display shows E8 and the grinder will not run on grind-and-brew Farberware models.
Grinder Motor / Jam Error
E9
Display shows E9 and the keep-warm function does not operate correctly.
Warming Plate Temperature Control Error
Symptom
Auto-brew (programmed start) does not work; coffee maker does not start at the set time.
Auto-Brew Timer / Programming Fault
Symptom
Brew basket overflows with coffee and grounds into the carafe or onto the counter.
Brew Basket Drainage Failure
Symptom
Burning or electrical smell during operation.
Overheating Component / Electrical Fault
Symptom
Buttons on the control panel are unresponsive or only work intermittently.
Keypad / Button Failure
Symptom
Carafe does not fill to the selected cup level; brews less coffee than expected.
Underfill / Incomplete Brew Volume
Symptom
Carafe drips or leaks when pouring, even with the lid on.
Carafe Spout / Lid Seal Leak
Symptom
Carafe overfills beyond the selected cup level.
Overfill / Excess Brew Volume
Symptom
Coffee is not hot enough when it finishes brewing.
Low Brew Temperature
Symptom
Coffee maker brews extremely slowly; a full pot takes much longer than normal.
Restricted Water Flow / Partial Blockage
Symptom
Coffee maker leaks water from the bottom during or after brewing.
Base Leak / Internal Seal Failure
Symptom
Coffee maker makes loud gurgling or popping noises during brewing.
Boiling Irregularities / Air in System
Symptom
Coffee maker powers on but will not start brewing when the brew button is pressed.
Brew Start / Control Logic Failure
Symptom
Coffee maker starts but stops brewing mid-cycle and shuts off.
Premature Brew Termination
Symptom
Coffee maker will not power on at all; no lights or display.
No Power / Dead Unit
Symptom
Coffee tastes bitter or burnt.
Over-Extraction / Overheating
Symptom
Coffee tastes weak even when using normal amounts of coffee.
Under-Extraction / Low Brew Temperature or Fast Flow
Symptom
Display clock or timer does not keep correct time or resets randomly.
Clock / Memory Power Loss
Symptom
Drip-stop feature does not work; coffee continues to drip when carafe is removed.
Drip-Stop Valve Failure
Symptom
Grind-and-brew model does not grind beans; only hot water passes through.
Grinder Not Activating
Symptom
Ground coffee appears in the carafe (sediment) more than usual.
Filter Bypass / Basket Seal Issue
Symptom
Keep-warm function does not work; coffee cools quickly after brewing.
Warming Plate Not Heating
Symptom
Strong plastic or chemical smell during first uses of the coffee maker.
New Appliance Off-Gassing / Residue Heating
Symptom
Unit shuts off immediately when the brew cycle is started.
Instant Power Cut / Protection Trip
Symptom
Unit vibrates excessively or rattles loudly during brewing.
Mechanical Vibration / Loose Components
Symptom
Visible steam escaping from areas other than the designated steam vent.
Steam Leak / Lid Seal Failure
Symptom
Warming plate stays on or very hot even after the coffee maker is turned off.
Warming Plate Stuck On
Symptom
Water leaks from the top around the brew basket or lid.
Overflow / Top-Side Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Display shows E1 and brewing will not start or stops immediately after pressing the brew button.
|
Water Reservoir Presence/Position Error | View Details |
| E2 |
Display shows E2 and the coffee maker will not heat or brew.
|
Overheat / Thermal Cutoff Protection Triggered | View Details |
| E3 |
Display shows E3 and brewing stops mid-cycle or never starts heating.
|
Temperature Sensor (NTC) Fault | View Details |
| E4 |
Display shows E4 and the coffee maker beeps without starting the brew cycle.
|
Water Flow / Pump Error | View Details |
| E5 |
Display shows E5 and the unit will not brew; sometimes accompanied by a lid or basket icon.
|
Brew Basket / Lid Not Closed Detection Error | View Details |
| E6 |
Display shows E6 and the clock or control panel becomes unresponsive.
|
Control Panel / Keypad Communication Error | View Details |
| E7 |
Display shows E7 and the unit shuts off shortly after starting a brew cycle.
|
Power Supply / Voltage Error | View Details |
| E8 |
Display shows E8 and the grinder will not run on grind-and-brew Farberware models.
|
Grinder Motor / Jam Error | View Details |
| E9 |
Display shows E9 and the keep-warm function does not operate correctly.
|
Warming Plate Temperature Control Error | View Details |
| – |
Auto-brew (programmed start) does not work; coffee maker does not start at the set time.
|
Auto-Brew Timer / Programming Fault | View Details |
| – |
Brew basket overflows with coffee and grounds into the carafe or onto the counter.
|
Brew Basket Drainage Failure | View Details |
| – |
Burning or electrical smell during operation.
|
Overheating Component / Electrical Fault | View Details |
| – |
Buttons on the control panel are unresponsive or only work intermittently.
|
Keypad / Button Failure | View Details |
| – |
Carafe does not fill to the selected cup level; brews less coffee than expected.
|
Underfill / Incomplete Brew Volume | View Details |
| – |
Carafe drips or leaks when pouring, even with the lid on.
|
Carafe Spout / Lid Seal Leak | View Details |
| – |
Carafe overfills beyond the selected cup level.
|
Overfill / Excess Brew Volume | View Details |
| – |
Coffee is not hot enough when it finishes brewing.
|
Low Brew Temperature | View Details |
| – |
Coffee maker brews extremely slowly; a full pot takes much longer than normal.
|
Restricted Water Flow / Partial Blockage | View Details |
| – |
Coffee maker leaks water from the bottom during or after brewing.
|
Base Leak / Internal Seal Failure | View Details |
| – |
Coffee maker makes loud gurgling or popping noises during brewing.
|
Boiling Irregularities / Air in System | View Details |
| – |
Coffee maker powers on but will not start brewing when the brew button is pressed.
|
Brew Start / Control Logic Failure | View Details |
| – |
Coffee maker starts but stops brewing mid-cycle and shuts off.
|
Premature Brew Termination | View Details |
| – |
Coffee maker will not power on at all; no lights or display.
|
No Power / Dead Unit | View Details |
| – |
Coffee tastes bitter or burnt.
|
Over-Extraction / Overheating | View Details |
| – |
Coffee tastes weak even when using normal amounts of coffee.
|
Under-Extraction / Low Brew Temperature or Fast Flow | View Details |
| – |
Display clock or timer does not keep correct time or resets randomly.
|
Clock / Memory Power Loss | View Details |
| – |
Drip-stop feature does not work; coffee continues to drip when carafe is removed.
|
Drip-Stop Valve Failure | View Details |
| – |
Grind-and-brew model does not grind beans; only hot water passes through.
|
Grinder Not Activating | View Details |
| – |
Ground coffee appears in the carafe (sediment) more than usual.
|
Filter Bypass / Basket Seal Issue | View Details |
| – |
Keep-warm function does not work; coffee cools quickly after brewing.
|
Warming Plate Not Heating | View Details |
| – |
Strong plastic or chemical smell during first uses of the coffee maker.
|
New Appliance Off-Gassing / Residue Heating | View Details |
| – |
Unit shuts off immediately when the brew cycle is started.
|
Instant Power Cut / Protection Trip | View Details |
| – |
Unit vibrates excessively or rattles loudly during brewing.
|
Mechanical Vibration / Loose Components | View Details |
| – |
Visible steam escaping from areas other than the designated steam vent.
|
Steam Leak / Lid Seal Failure | View Details |
| – |
Warming plate stays on or very hot even after the coffee maker is turned off.
|
Warming Plate Stuck On | View Details |
| – |
Water leaks from the top around the brew basket or lid.
|
Overflow / Top-Side Leak | View Details |
No matching codes found
Advertisements