Severin
Severin Air Fryers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Air fryer will not start; display shows E1 immediately after power-on or when pressing the start button.
NTC Temperature Sensor Open Circuit
E10
E10 displayed; unit beeps and refuses to start, often after a power surge or outage.
EEPROM or Configuration Data Error
E2
Air fryer stops heating and displays E2 during preheat or cooking.
NTC Temperature Sensor Short Circuit
E3
Display shows E3 and the air fryer shuts off heating shortly after starting a program.
Overtemperature Protection Triggered (Chamber Overheat)
E4
Air fryer beeps and shows E4; fan may run but heater does not engage.
Overcurrent or Heater Circuit Fault
E5
Display shows E5 and the unit will not start a cooking cycle.
Fan Motor Fault or Fan Tachometer Error
E6
Air fryer powers on but shows E6 and does not respond to temperature or time settings.
Control Panel Communication Error
E7
E7 appears on the display and the unit shuts down shortly after starting, often accompanied by a clicking sound.
Power Supply or Low Voltage Error
E8
Display shows E8 and the air fryer will not heat, though the fan may still run.
Relay or Triac Drive Failure
E9
E9 error appears intermittently; unit may shut off mid‑cycle without obvious overheating.
Internal Overheat or PCB Temperature Sensor Fault
Symptom
Air fryer does not power on at all; no lights or display when plugged in.
No Power / Dead Appliance
Symptom
Air fryer emits a burning plastic smell during use.
Overheating Plastic Components
Symptom
Air fryer exterior becomes extremely hot to touch, especially on sides or top.
Insulation or Airflow Deficiency
Symptom
Air fryer heats but takes much longer than usual to reach temperature; food is undercooked at normal times.
Reduced Heating Output
Symptom
Air fryer powers on and fan runs, but there is no heat; food remains uncooked.
No Heating / Open Heater Circuit
Symptom
Air fryer shuts off mid‑cycle and restarts or remains off without any error code.
Intermittent Power Loss
Symptom
Basket will not fully insert or the unit does not start even though the basket appears closed.
Drawer / Basket Insertion Switch Fault
Symptom
Buttons register by themselves or change settings without being touched.
Phantom Touch / Touch Panel Interference
Symptom
Condensation or small water droplets appear around the control panel or on the countertop.
Steam Condensation Leakage
Symptom
Display is very dim or flickers during operation.
Low Logic Supply Voltage / Display Driver Issue
Symptom
Display lights up but buttons do not respond or respond intermittently.
Unresponsive Touch Control Panel
Symptom
Drawer is difficult to slide in or out; it sticks or grinds.
Drawer Rail Misalignment / Contamination
Symptom
Drawer or basket coating is peeling or flaking.
Non‑Stick Coating Degradation
Symptom
Fan makes loud rattling or scraping noises during operation.
Convection Fan Mechanical Noise
Symptom
Food cooks unevenly; some areas are burnt while others are undercooked.
Uneven Airflow / Temperature Distribution
Symptom
High‑pitched squealing noise from the top of the air fryer during operation.
Fan Motor Bearing Wear
Symptom
LED indicators work but the numeric display segments are missing or partially lit.
Segment Failure on Display
Symptom
Strong burnt food smell that persists even after cleaning.
Grease and Residue Carbonization
Symptom
Temperature on display does not match actual cooking temperature; food is consistently over‑ or under‑done.
Temperature Calibration / Sensor Drift
Symptom
Timer counts down but fan and heater do not start; only the display is active.
Output Stage Failure (Fan and Heater)
Symptom
Unit beeps repeatedly and will not start, even though the display appears normal.
Safety Interlock Not Engaged
Symptom
Unit continues to run the fan for an unusually long time after the timer reaches zero.
Cooling Cycle Overrun
Symptom
Unit makes a clicking sound repeatedly but does not heat properly.
Relay Chattering / Unstable Heater Control
Symptom
Unit trips the household circuit breaker or RCD when starting or during heating.
Electrical Short or Earth Leakage
Symptom
Unit vibrates excessively or moves slightly on the countertop during operation.
Excessive Vibration
Symptom
Visible smoke coming from the air fryer during normal cooking (not just initial preheat).
Excessive Grease Smoke
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Air fryer will not start; display shows E1 immediately after power-on or when pressing the start button.
|
NTC Temperature Sensor Open Circuit | View Details |
| E10 |
E10 displayed; unit beeps and refuses to start, often after a power surge or outage.
|
EEPROM or Configuration Data Error | View Details |
| E2 |
Air fryer stops heating and displays E2 during preheat or cooking.
|
NTC Temperature Sensor Short Circuit | View Details |
| E3 |
Display shows E3 and the air fryer shuts off heating shortly after starting a program.
|
Overtemperature Protection Triggered (Chamber Overheat) | View Details |
| E4 |
Air fryer beeps and shows E4; fan may run but heater does not engage.
|
Overcurrent or Heater Circuit Fault | View Details |
| E5 |
Display shows E5 and the unit will not start a cooking cycle.
|
Fan Motor Fault or Fan Tachometer Error | View Details |
| E6 |
Air fryer powers on but shows E6 and does not respond to temperature or time settings.
|
Control Panel Communication Error | View Details |
| E7 |
E7 appears on the display and the unit shuts down shortly after starting, often accompanied by a clicking sound.
|
Power Supply or Low Voltage Error | View Details |
| E8 |
Display shows E8 and the air fryer will not heat, though the fan may still run.
|
Relay or Triac Drive Failure | View Details |
| E9 |
E9 error appears intermittently; unit may shut off mid‑cycle without obvious overheating.
|
Internal Overheat or PCB Temperature Sensor Fault | View Details |
| – |
Air fryer does not power on at all; no lights or display when plugged in.
|
No Power / Dead Appliance | View Details |
| – |
Air fryer emits a burning plastic smell during use.
|
Overheating Plastic Components | View Details |
| – |
Air fryer exterior becomes extremely hot to touch, especially on sides or top.
|
Insulation or Airflow Deficiency | View Details |
| – |
Air fryer heats but takes much longer than usual to reach temperature; food is undercooked at normal times.
|
Reduced Heating Output | View Details |
| – |
Air fryer powers on and fan runs, but there is no heat; food remains uncooked.
|
No Heating / Open Heater Circuit | View Details |
| – |
Air fryer shuts off mid‑cycle and restarts or remains off without any error code.
|
Intermittent Power Loss | View Details |
| – |
Basket will not fully insert or the unit does not start even though the basket appears closed.
|
Drawer / Basket Insertion Switch Fault | View Details |
| – |
Buttons register by themselves or change settings without being touched.
|
Phantom Touch / Touch Panel Interference | View Details |
| – |
Condensation or small water droplets appear around the control panel or on the countertop.
|
Steam Condensation Leakage | View Details |
| – |
Display is very dim or flickers during operation.
|
Low Logic Supply Voltage / Display Driver Issue | View Details |
| – |
Display lights up but buttons do not respond or respond intermittently.
|
Unresponsive Touch Control Panel | View Details |
| – |
Drawer is difficult to slide in or out; it sticks or grinds.
|
Drawer Rail Misalignment / Contamination | View Details |
| – |
Drawer or basket coating is peeling or flaking.
|
Non‑Stick Coating Degradation | View Details |
| – |
Fan makes loud rattling or scraping noises during operation.
|
Convection Fan Mechanical Noise | View Details |
| – |
Food cooks unevenly; some areas are burnt while others are undercooked.
|
Uneven Airflow / Temperature Distribution | View Details |
| – |
High‑pitched squealing noise from the top of the air fryer during operation.
|
Fan Motor Bearing Wear | View Details |
| – |
LED indicators work but the numeric display segments are missing or partially lit.
|
Segment Failure on Display | View Details |
| – |
Strong burnt food smell that persists even after cleaning.
|
Grease and Residue Carbonization | View Details |
| – |
Temperature on display does not match actual cooking temperature; food is consistently over‑ or under‑done.
|
Temperature Calibration / Sensor Drift | View Details |
| – |
Timer counts down but fan and heater do not start; only the display is active.
|
Output Stage Failure (Fan and Heater) | View Details |
| – |
Unit beeps repeatedly and will not start, even though the display appears normal.
|
Safety Interlock Not Engaged | View Details |
| – |
Unit continues to run the fan for an unusually long time after the timer reaches zero.
|
Cooling Cycle Overrun | View Details |
| – |
Unit makes a clicking sound repeatedly but does not heat properly.
|
Relay Chattering / Unstable Heater Control | View Details |
| – |
Unit trips the household circuit breaker or RCD when starting or during heating.
|
Electrical Short or Earth Leakage | View Details |
| – |
Unit vibrates excessively or moves slightly on the countertop during operation.
|
Excessive Vibration | View Details |
| – |
Visible smoke coming from the air fryer during normal cooking (not just initial preheat).
|
Excessive Grease Smoke | View Details |
No matching codes found
Advertisements