Midea

Midea Ice Makers Error Codes

Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.

Advertisements
E1
Ice maker stops and displays E1; unit may beep and compressor does not start
Cabinet Temperature Sensor (Thermistor) Failure
E10
E10 displayed; ice maker stops, internal communication or control seems erratic
Main Control Board Communication / EEPROM Error
E11
E11 error; ice bin full indicator is on even when bin is empty, or machine stops prematurely
Ice Bin Full Sensor / Infrared Beam Failure
E12
E12 displayed; ice maker cycles but produces very small or hollow cubes, then stops with error
Low Refrigerant / Compressor Protection Error (Temperature/Pressure Out of Range)
E13
E13 error; internal drain pump runs continuously or unit reports drain fault
Drain Pump / Drain Level Sensor Failure
E14
E14 displayed; ice maker stops and may indicate door or lid open even when closed
Door / Lid Switch Failure
E15
E15 error; ice maker reports sensor fault after cleaning cycle or power surge
Multiple Sensor Fault / Sensor Bus Error
E2
E2 displayed; ice maker runs briefly then stops, fan may not operate correctly
Ambient / Cabinet Air Temperature Sensor Failure
E3
E3 error; ice maker stops mid-cycle, ice thickness is inconsistent or machine aborts harvest
Ice Thickness Sensor / Probe Failure
E4
E4 displayed; ice maker stops, compressor may run briefly then shut off, possible frost buildup
Defrost / Evaporator Temperature Abnormality
E5
E5 error; ice maker stops, water does not fill properly or overfills the evaporator tray
Water Level Sensor / Float Switch Failure
E6
E6 displayed; ice maker does not harvest ice, ice slab remains stuck on evaporator
Harvest Motor / Ice Tray Motor Failure
E7
E7 error; ice maker fan does not run, unit overheats or makes no ice
Condenser Fan Motor Failure
E8
E8 displayed; ice maker stops, water does not circulate over evaporator properly
Water Circulation Pump Failure
E9
E9 error; ice maker does not fill with water, or fills very slowly
Water Inlet Valve / Fill Valve Failure
Symptom
Display works but some buttons do not respond
Keypad / Touch Control Failure
Symptom
Evaporator does not frost at all while compressor is running
No Cooling – Sealed System Failure
Symptom
Evaporator plate freezes into a solid block of ice and does not release
Harvest Failure / Defrost Timing Issue
Symptom
Ice appears cloudy or white instead of clear
Entrained Air / Mineral Content in Ice
Symptom
Ice bin overflows with ice and does not stop production
Bin Full Detection Failure
Symptom
Ice cubes are too large or fused together in sheets
Excessive Water Fill / Delayed Harvest
Symptom
Ice cubes are too small or hollow
Insufficient Water Fill / Premature Harvest
Symptom
Ice has a bad taste or odor
Contaminated Water Path / Biofilm or Odor Absorption
Symptom
Ice maker interior shows heavy scale and slime buildup
Lack of Regular Cleaning / Sanitation
Symptom
Ice maker is leaking water onto the floor
External Water Leak
Symptom
Ice maker is very noisy during operation (grinding, rattling, or buzzing)
Mechanical Noise – Fan, Pump, or Compressor Related
Symptom
Ice maker powers on but will not start a cycle (stuck in standby)
Control Logic / User Interface Lock
Symptom
Ice maker produces ice but shuts off earlier than expected each day
Capacity Limitation / Thermal Protection
Symptom
Ice maker produces ice very slowly compared to normal
Reduced Ice Production – Thermal/Flow Inefficiency
Symptom
Ice maker runs but produces no ice at all
No Ice Production – General Failure
Symptom
Ice maker stops after a few minutes and then restarts repeatedly
Short Cycling – Overheat or Sensor Misread
Symptom
Ice maker vibrates excessively or walks on the counter/floor
Excessive Vibration / Poor Leveling
Symptom
Ice maker will not power on at all (no lights, no sounds)
No Power / Electrical Supply Failure
Symptom
Ice melts quickly or bin temperature seems too warm
Poor Ice Storage Cooling / Insulation Issue
Symptom
Loud knocking or banging sound during harvest
Harvest Mechanism Impact / Ice Tray Misalignment
Symptom
Unit stuck in cleaning mode and will not return to normal ice making
Control Mode Stuck / Software State Error
Symptom
Unit trips the household breaker or GFCI when starting
Electrical Short / Ground Fault
Symptom
Water leaking inside the ice bin or from the evaporator area
Internal Ice Compartment Leak / Poor Drainage
Symptom
Water pump runs but no water reaches the evaporator
Water Circulation Blockage
Advertisements