Whynter
Whynter Ice Makers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
Add
“Add Water” light or code stays on, ice maker will not start cycle
Water Supply / Level Detection Issue
dr
“dr” or drain code appears on built-in Whynter ice maker, unit may stop
Drain Pump / Drain System Fault
E1
Whynter ice maker beeps and displays E1, unit will not start ice-making cycle
Ambient Temperature Sensor Failure
E2
Whynter ice maker shows E2 and stops making ice, fan may still run
Evaporator Temperature Sensor Failure
E3
Display shows E3, ice maker stops mid-cycle or will not start
Water Level Sensor / Float Switch Error
E4
Whynter ice maker displays E4 and stops, often after running briefly
Ice Full Sensor / Bin Sensor Error
E5
E5 error on display, compressor does not start or shuts down quickly
Compressor Overload / High Temperature Protection
E6
E6 error code, unit powers on but no ice is produced
Refrigeration System Fault / Low Refrigerant or Sensor Logic Error
E7
E7 displayed, ice maker stops and may beep continuously
Ice Thickness Sensor / Probe Error
E8
E8 error, unit may fill with water but does not harvest ice properly
Harvest Motor / Ice Tray Motor Error
E9
E9 error code, unit may shut down shortly after starting
Internal Communication / Control Board Error
F1
F1 error on Whynter built-in ice maker, unit will not run
Freezer Compartment Temperature Sensor Fault
F2
F2 error, ice maker runs but temperature is not controlled properly
Defrost Sensor / Evaporator Sensor Fault (Built-in Models)
F3
F3 error on display, ice maker may not defrost or may over-ice
Defrost Heater or Defrost Circuit Failure
F4
F4 error, ice maker may not start compressor or may shut down unexpectedly
Compressor Relay / Start Device Fault
H1
H1 or HI temperature warning, ice compartment too warm
High Temperature Alarm / Inadequate Cooling
HI
HI or FULL indicator stays on even when ice bin is empty, unit will not make ice
False Ice Bin Full Detection
LO
LO or LOW water indicator on display, unit beeps and stops making ice
Low Water Level Detected
Symptom
Clicking sound, compressor tries to start but shuts off repeatedly, no cooling
Compressor Start Failure
Symptom
Display works but buttons do not respond or respond intermittently
Keypad / Control Panel Failure
Symptom
High-pitched squealing or whirring noise while running
Fan or Pump Bearing Wear
Symptom
Ice cubes are too large and may jam the mechanism
Excessive Ice Thickness
Symptom
Ice cubes are too small or hollow
Insufficient Water Fill / Short Freeze Time
Symptom
Ice has a bad taste or odor
Contaminated Water or Internal Surfaces
Symptom
Ice maker does not power on at all, no lights or display
No Power / Dead Unit
Symptom
Ice maker leaks water onto the counter or floor
External Water Leak
Symptom
Ice maker makes ice very slowly, long time between batches
Reduced Cooling Capacity / Inefficient Operation
Symptom
Ice maker powers on but will not start ice-making cycle (no water fill, no compressor)
Control Logic / Start-Up Failure
Symptom
Ice maker runs but makes no ice at all (compressor may or may not run)
No Ice Production
Symptom
Ice maker vibrates excessively or rattles against surfaces
Excessive Vibration / Poor Leveling
Symptom
Ice melts quickly in the bin or bin is warm
Poor Ice Storage Insulation / Warm Bin
Symptom
Loud grinding or rattling noise during ice-making cycle
Mechanical Drive or Fan Noise
Symptom
Unit forms ice on evaporator but does not release it into the bin
Harvest Failure / Ice Sticking to Evaporator
Symptom
Unit frequently freezes up with heavy frost on evaporator and walls
Excessive Frost / Defrost Problem (Built-in Models)
Symptom
Unit overflows ice, bin does not stop filling
Ice Bin Full Detection Failure
Symptom
Unit trips circuit breaker or GFCI when starting
Electrical Short or Ground Fault
Symptom
Visible mold, slime, or mineral scale inside ice maker
Lack of Cleaning / Biofilm and Scale Buildup
Symptom
Water leaking inside the ice compartment, forming ice sheets or puddles
Internal Water Leak / Overflow
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| Add |
“Add Water” light or code stays on, ice maker will not start cycle
|
Water Supply / Level Detection Issue | View Details |
| dr |
“dr” or drain code appears on built-in Whynter ice maker, unit may stop
|
Drain Pump / Drain System Fault | View Details |
| E1 |
Whynter ice maker beeps and displays E1, unit will not start ice-making cycle
|
Ambient Temperature Sensor Failure | View Details |
| E2 |
Whynter ice maker shows E2 and stops making ice, fan may still run
|
Evaporator Temperature Sensor Failure | View Details |
| E3 |
Display shows E3, ice maker stops mid-cycle or will not start
|
Water Level Sensor / Float Switch Error | View Details |
| E4 |
Whynter ice maker displays E4 and stops, often after running briefly
|
Ice Full Sensor / Bin Sensor Error | View Details |
| E5 |
E5 error on display, compressor does not start or shuts down quickly
|
Compressor Overload / High Temperature Protection | View Details |
| E6 |
E6 error code, unit powers on but no ice is produced
|
Refrigeration System Fault / Low Refrigerant or Sensor Logic Error | View Details |
| E7 |
E7 displayed, ice maker stops and may beep continuously
|
Ice Thickness Sensor / Probe Error | View Details |
| E8 |
E8 error, unit may fill with water but does not harvest ice properly
|
Harvest Motor / Ice Tray Motor Error | View Details |
| E9 |
E9 error code, unit may shut down shortly after starting
|
Internal Communication / Control Board Error | View Details |
| F1 |
F1 error on Whynter built-in ice maker, unit will not run
|
Freezer Compartment Temperature Sensor Fault | View Details |
| F2 |
F2 error, ice maker runs but temperature is not controlled properly
|
Defrost Sensor / Evaporator Sensor Fault (Built-in Models) | View Details |
| F3 |
F3 error on display, ice maker may not defrost or may over-ice
|
Defrost Heater or Defrost Circuit Failure | View Details |
| F4 |
F4 error, ice maker may not start compressor or may shut down unexpectedly
|
Compressor Relay / Start Device Fault | View Details |
| H1 |
H1 or HI temperature warning, ice compartment too warm
|
High Temperature Alarm / Inadequate Cooling | View Details |
| HI |
HI or FULL indicator stays on even when ice bin is empty, unit will not make ice
|
False Ice Bin Full Detection | View Details |
| LO |
LO or LOW water indicator on display, unit beeps and stops making ice
|
Low Water Level Detected | View Details |
| – |
Clicking sound, compressor tries to start but shuts off repeatedly, no cooling
|
Compressor Start Failure | View Details |
| – |
Display works but buttons do not respond or respond intermittently
|
Keypad / Control Panel Failure | View Details |
| – |
High-pitched squealing or whirring noise while running
|
Fan or Pump Bearing Wear | View Details |
| – |
Ice cubes are too large and may jam the mechanism
|
Excessive Ice Thickness | View Details |
| – |
Ice cubes are too small or hollow
|
Insufficient Water Fill / Short Freeze Time | View Details |
| – |
Ice has a bad taste or odor
|
Contaminated Water or Internal Surfaces | View Details |
| – |
Ice maker does not power on at all, no lights or display
|
No Power / Dead Unit | View Details |
| – |
Ice maker leaks water onto the counter or floor
|
External Water Leak | View Details |
| – |
Ice maker makes ice very slowly, long time between batches
|
Reduced Cooling Capacity / Inefficient Operation | View Details |
| – |
Ice maker powers on but will not start ice-making cycle (no water fill, no compressor)
|
Control Logic / Start-Up Failure | View Details |
| – |
Ice maker runs but makes no ice at all (compressor may or may not run)
|
No Ice Production | View Details |
| – |
Ice maker vibrates excessively or rattles against surfaces
|
Excessive Vibration / Poor Leveling | View Details |
| – |
Ice melts quickly in the bin or bin is warm
|
Poor Ice Storage Insulation / Warm Bin | View Details |
| – |
Loud grinding or rattling noise during ice-making cycle
|
Mechanical Drive or Fan Noise | View Details |
| – |
Unit forms ice on evaporator but does not release it into the bin
|
Harvest Failure / Ice Sticking to Evaporator | View Details |
| – |
Unit frequently freezes up with heavy frost on evaporator and walls
|
Excessive Frost / Defrost Problem (Built-in Models) | View Details |
| – |
Unit overflows ice, bin does not stop filling
|
Ice Bin Full Detection Failure | View Details |
| – |
Unit trips circuit breaker or GFCI when starting
|
Electrical Short or Ground Fault | View Details |
| – |
Visible mold, slime, or mineral scale inside ice maker
|
Lack of Cleaning / Biofilm and Scale Buildup | View Details |
| – |
Water leaking inside the ice compartment, forming ice sheets or puddles
|
Internal Water Leak / Overflow | View Details |
No matching codes found
Advertisements