Emeril Lagasse

Emeril Lagasse Air Fryers Error Codes

Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.

Advertisements
E1
Display shows E1 and cooking will not start or stops immediately on Emeril Lagasse air fryer ovens and basket models.
NTC Temperature Sensor Open Circuit
E2
Display shows E2 and the Emeril Lagasse air fryer will not heat or stops mid-cycle.
NTC Temperature Sensor Short Circuit / Overtemperature Detection
E3
Display shows E3 and the Emeril Lagasse air fryer will not start or shuts down shortly after starting.
Overheat Protection / High Temperature Fault
E4
Display shows E4 and the Emeril Lagasse air fryer will not heat or stops with a beeping alarm.
Heater Circuit Fault / Overcurrent Protection
E5
Display shows E5 and the Emeril Lagasse air fryer will not start or shuts off shortly after starting.
Power Supply / Low Voltage / Internal Board Fault
E6
Display shows E6 and the Emeril Lagasse air fryer will not start or stops mid-cycle.
Fan Motor Circuit Fault
E7
Display shows E7 and the Emeril Lagasse air fryer will not start or shuts off with a beeping alarm.
Door / Basket Detection Fault
E8
Display shows E8 and the Emeril Lagasse air fryer will not start or randomly shuts off.
Internal Communication / Control Board Fault
E9
Display shows E9 and the Emeril Lagasse air fryer will not start or immediately shuts off.
EEPROM / Memory Error on Control Board
Symptom
Air fryer does not power on at all; no lights, no display, no response to buttons.
No Power / Dead Unit
Symptom
Air fryer emits a burning plastic or electrical smell during use.
Overheating Wiring or Component Failure
Symptom
Air fryer leaks grease or liquid onto the countertop or inside the base.
Drip Management / Seal Failure
Symptom
Air fryer powers on but shuts off randomly during cooking without any error code.
Intermittent Power Loss / Overheat Trip
Symptom
Air fryer powers on but will not heat; fan runs and timer counts down, but food remains cold.
Open Heating Element Circuit
Symptom
Basket will not slide in fully or is difficult to insert on basket-style Emeril Lagasse air fryers.
Basket Rail / Frame Deformation
Symptom
Control buttons are unresponsive or only some buttons work intermittently.
Keypad / Touch Panel Failure
Symptom
Display is dim, flickering, or segments are missing, but the fryer still operates.
LED / Display Module Degradation
Symptom
Door does not close fully or pops open during cooking on oven-style Emeril Lagasse air fryers.
Door Latch / Hinge Misalignment
Symptom
Door glass is cracked or shattered.
Door Assembly Damage
Symptom
Excessive smoke coming from the air fryer during cooking, especially at higher temperatures.
Grease Ignition / Oil Smoke
Symptom
Fan does not run; heater may get hot but there is little or no air circulation.
Convection Fan Failure
Symptom
Food cooks unevenly; back side browns more than front or one side is consistently underdone.
Uneven Airflow / Hot Spotting
Symptom
Interior coating is peeling or flaking, and flakes appear in food.
Cavity / Basket Non-Stick Coating Failure
Symptom
Interior light does not turn on, but the fryer otherwise works normally.
Cavity Light Failure
Symptom
Loud rattling, grinding, or scraping noise from the air fryer during operation.
Mechanical Noise from Fan or Internal Components
Symptom
Outer surfaces of the air fryer become excessively hot to the touch during normal use.
Insulation / Heat Shield Degradation
Symptom
Rattling or buzzing noise from inside the control area when the heater turns on.
Noisy Relay or Loose Component on Control Board
Symptom
Strong chemical or plastic smell persists after several uses with no visible damage.
Residue Burn-off / Manufacturing Oils
Symptom
Temperature is inaccurate; food undercooks or overcooks compared to the set temperature.
Temperature Regulation / Calibration Error
Symptom
Timer counts down but heater and fan do not run; unit appears on but does not cook.
Output Control Failure
Symptom
Unit beeps repeatedly and will not start when the Start button is pressed, but no error code is shown.
Door/Basket Not Detected (No-Code Condition)
Symptom
Unit emits a high-pitched whine or electrical squeal during operation.
Switching Power Supply / Coil Whine
Symptom
Unit takes much longer than normal to reach temperature or never seems to get fully hot.
Reduced Heating Output
Symptom
Unit trips the household circuit breaker or GFCI when plugged in or when starting a cycle.
Short Circuit / Ground Fault
Symptom
Unit turns on by itself or changes settings without user input.
Phantom Touch / Control Panel Short
Symptom
Unit vibrates excessively or moves on the countertop during operation.
Imbalance / Fan Vibration
Advertisements