Severin
Severin Microwaves Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Microwave will not start; display shows E01 immediately after pressing START.
Door Interlock Safety Circuit Fault
E02
Microwave stops a few seconds after starting and displays E02.
Overheat / Thermal Cut-Out Activation
E03
Microwave beeps and shows E03; cooking does not start.
Keypad / Control Panel Communication Error
E04
Microwave runs but stops with E04 error; food remains cold.
Magnetron / High-Voltage Circuit Fault Detection
E05
Microwave displays E05 and will not start any cooking program.
Cavity Temperature Sensor (NTC) Error
E06
Microwave shows E06 and beeps; grill or convection functions do not start.
Grill / Convection Heater Circuit Fault
E07
Microwave displays E07 and stops; turntable may not rotate.
Turntable Motor / Rotation Sensor Error
E08
Microwave shows E08; interior light and display work but unit will not heat.
Low Voltage / Power Supply Error
E09
Microwave intermittently shuts off and displays E09 during cooking.
Input Voltage Fluctuation / Brownout Detection
E10
Microwave shows E10 and beeps continuously; no functions can be selected.
EEPROM / Control Board Memory Error
E11
Microwave displays E11; child lock cannot be disabled or buttons do not respond correctly.
Child Lock / Keypad Logic Fault
E12
Microwave shows E12 when starting grill or combination mode; microwave-only mode may still work.
Convection Fan / Airflow Fault
E13
Microwave displays E13 and stops; interior light may flicker.
Door Sense / Latch Alignment Error
E14
Microwave shows E14; clock and display work but no cooking modes can be selected.
Mode Selector / Relay Matrix Fault
E15
Microwave displays E15 and stops; a loud humming noise may be heard before shutdown.
High-Voltage Overcurrent / Short Detection
E16
Microwave shows E16; fan and light may run but no heating occurs.
Inverter Power Module Fault (for inverter-based models)
E17
Microwave displays E17 and will not start; interior light may stay on with door closed.
Monitor Switch / Safety Interlock Error
E18
Microwave shows E18; interior light and fan may run continuously until unplugged.
Stuck Relay / Control Output Fault
E19
Microwave displays E19; timer counts down but no heating or fan operation.
Output Drive Failure / No Load Activation
Symptom
Microwave cavity shows rust spots, especially around the door frame or floor.
Cavity Corrosion
Symptom
Microwave clock and settings reset every time the plug is removed or there is a brief power interruption.
Non-Volatile Memory / Backup Power Loss
Symptom
Microwave convection mode does not reach or maintain the set temperature.
Convection Heating / Temperature Regulation Fault
Symptom
Microwave display and clock are dead; unit shows no signs of power.
No Power / Dead Appliance
Symptom
Microwave display works, but pressing buttons does nothing or only some buttons respond.
Keypad / Membrane Failure
Symptom
Microwave door does not close properly; cooking stops when the door is slightly touched.
Door Misalignment / Weak Latch Engagement
Symptom
Microwave door will not open or is very hard to open after cooking.
Door Latch / Release Mechanism Jam
Symptom
Microwave emits a burning smell or smoke during operation.
Overheating Component or Cavity Contamination
Symptom
Microwave emits a high-pitched squeal or whine from the fan area.
Cooling Fan Bearing Wear
Symptom
Microwave exterior or control panel becomes excessively hot to the touch during use.
Insufficient Ventilation / Cooling Failure
Symptom
Microwave grill function does not brown food; grill element does not glow red.
Grill Element Underheating
Symptom
Microwave heats, but there are visible sparks or arcing inside the cavity, often near the side wall or mica cover.
Cavity Arcing / Waveguide Contamination
Symptom
Microwave interior light does not come on, but the unit heats and operates normally.
Interior Lamp Failure
Symptom
Microwave is very noisy; rattling or grinding sounds from the turntable area.
Turntable Drive Mechanical Noise
Symptom
Microwave makes a loud buzzing or humming noise during operation, louder than usual.
High-Voltage Transformer or Magnetron Noise
Symptom
Microwave produces condensation or water droplets on the door and interior surfaces.
Normal Condensation / Ventilation Issue
Symptom
Microwave runs (light, fan, turntable) but does not heat food at all.
No Microwave Output
Symptom
Microwave runs but food heats unevenly; some areas are very hot while others are cold.
Uneven Heating / Standing Wave Pattern
Symptom
Microwave runs with the door open or starts when the door is closed without pressing START.
Door Interlock System Failure
Symptom
Microwave timer counts down too fast or too slow compared to real time.
Control Timing / Oscillator Fault
Symptom
Microwave trips the household circuit breaker or blows fuses when starting.
Short Circuit / Overcurrent on Startup
Symptom
Microwave turntable does not rotate, but heating still occurs.
Turntable Drive Failure
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Microwave will not start; display shows E01 immediately after pressing START.
|
Door Interlock Safety Circuit Fault | View Details |
| E02 |
Microwave stops a few seconds after starting and displays E02.
|
Overheat / Thermal Cut-Out Activation | View Details |
| E03 |
Microwave beeps and shows E03; cooking does not start.
|
Keypad / Control Panel Communication Error | View Details |
| E04 |
Microwave runs but stops with E04 error; food remains cold.
|
Magnetron / High-Voltage Circuit Fault Detection | View Details |
| E05 |
Microwave displays E05 and will not start any cooking program.
|
Cavity Temperature Sensor (NTC) Error | View Details |
| E06 |
Microwave shows E06 and beeps; grill or convection functions do not start.
|
Grill / Convection Heater Circuit Fault | View Details |
| E07 |
Microwave displays E07 and stops; turntable may not rotate.
|
Turntable Motor / Rotation Sensor Error | View Details |
| E08 |
Microwave shows E08; interior light and display work but unit will not heat.
|
Low Voltage / Power Supply Error | View Details |
| E09 |
Microwave intermittently shuts off and displays E09 during cooking.
|
Input Voltage Fluctuation / Brownout Detection | View Details |
| E10 |
Microwave shows E10 and beeps continuously; no functions can be selected.
|
EEPROM / Control Board Memory Error | View Details |
| E11 |
Microwave displays E11; child lock cannot be disabled or buttons do not respond correctly.
|
Child Lock / Keypad Logic Fault | View Details |
| E12 |
Microwave shows E12 when starting grill or combination mode; microwave-only mode may still work.
|
Convection Fan / Airflow Fault | View Details |
| E13 |
Microwave displays E13 and stops; interior light may flicker.
|
Door Sense / Latch Alignment Error | View Details |
| E14 |
Microwave shows E14; clock and display work but no cooking modes can be selected.
|
Mode Selector / Relay Matrix Fault | View Details |
| E15 |
Microwave displays E15 and stops; a loud humming noise may be heard before shutdown.
|
High-Voltage Overcurrent / Short Detection | View Details |
| E16 |
Microwave shows E16; fan and light may run but no heating occurs.
|
Inverter Power Module Fault (for inverter-based models) | View Details |
| E17 |
Microwave displays E17 and will not start; interior light may stay on with door closed.
|
Monitor Switch / Safety Interlock Error | View Details |
| E18 |
Microwave shows E18; interior light and fan may run continuously until unplugged.
|
Stuck Relay / Control Output Fault | View Details |
| E19 |
Microwave displays E19; timer counts down but no heating or fan operation.
|
Output Drive Failure / No Load Activation | View Details |
| – |
Microwave cavity shows rust spots, especially around the door frame or floor.
|
Cavity Corrosion | View Details |
| – |
Microwave clock and settings reset every time the plug is removed or there is a brief power interruption.
|
Non-Volatile Memory / Backup Power Loss | View Details |
| – |
Microwave convection mode does not reach or maintain the set temperature.
|
Convection Heating / Temperature Regulation Fault | View Details |
| – |
Microwave display and clock are dead; unit shows no signs of power.
|
No Power / Dead Appliance | View Details |
| – |
Microwave display works, but pressing buttons does nothing or only some buttons respond.
|
Keypad / Membrane Failure | View Details |
| – |
Microwave door does not close properly; cooking stops when the door is slightly touched.
|
Door Misalignment / Weak Latch Engagement | View Details |
| – |
Microwave door will not open or is very hard to open after cooking.
|
Door Latch / Release Mechanism Jam | View Details |
| – |
Microwave emits a burning smell or smoke during operation.
|
Overheating Component or Cavity Contamination | View Details |
| – |
Microwave emits a high-pitched squeal or whine from the fan area.
|
Cooling Fan Bearing Wear | View Details |
| – |
Microwave exterior or control panel becomes excessively hot to the touch during use.
|
Insufficient Ventilation / Cooling Failure | View Details |
| – |
Microwave grill function does not brown food; grill element does not glow red.
|
Grill Element Underheating | View Details |
| – |
Microwave heats, but there are visible sparks or arcing inside the cavity, often near the side wall or mica cover.
|
Cavity Arcing / Waveguide Contamination | View Details |
| – |
Microwave interior light does not come on, but the unit heats and operates normally.
|
Interior Lamp Failure | View Details |
| – |
Microwave is very noisy; rattling or grinding sounds from the turntable area.
|
Turntable Drive Mechanical Noise | View Details |
| – |
Microwave makes a loud buzzing or humming noise during operation, louder than usual.
|
High-Voltage Transformer or Magnetron Noise | View Details |
| – |
Microwave produces condensation or water droplets on the door and interior surfaces.
|
Normal Condensation / Ventilation Issue | View Details |
| – |
Microwave runs (light, fan, turntable) but does not heat food at all.
|
No Microwave Output | View Details |
| – |
Microwave runs but food heats unevenly; some areas are very hot while others are cold.
|
Uneven Heating / Standing Wave Pattern | View Details |
| – |
Microwave runs with the door open or starts when the door is closed without pressing START.
|
Door Interlock System Failure | View Details |
| – |
Microwave timer counts down too fast or too slow compared to real time.
|
Control Timing / Oscillator Fault | View Details |
| – |
Microwave trips the household circuit breaker or blows fuses when starting.
|
Short Circuit / Overcurrent on Startup | View Details |
| – |
Microwave turntable does not rotate, but heating still occurs.
|
Turntable Drive Failure | View Details |
No matching codes found
Advertisements