Liebherr Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer will not start a program; display shows E01 immediately after pressing Start.
Door Lock Failure
E02
Washer-dryer does not fill with water; E02 appears shortly after program start.
Water Inlet Fault
E03
Washer-dryer does not drain; water remains in drum and E03 is displayed.
Drain Pump or Drainage Fault
E04
Washer-dryer overfills or shows E04 with water visible in the door glass above normal level.
Overfill / Water Level Sensor Fault
E05
Washer-dryer does not heat during wash; cycles take unusually long and E05 appears.
Wash Heating Circuit Fault
E06
Washer-dryer does not spin; drum turns slowly or not at all and E06 is displayed.
Motor Drive Fault
E07
Washer-dryer stops mid-cycle with E07; drum may be locked and will not rotate by hand.
Drum Lock / Motor Jam Fault
E08
Washer-dryer shows E08 and will not start drying; washing functions may still work.
Dryer Heating Circuit Fault
E09
Drying performance is poor or non-existent; E09 appears near the end of the drying cycle.
Dryer Condenser / Moisture Sensing Fault
E10
Washer-dryer displays E10 and stops; water may be visible in the base tray or machine may have pumped out unexpectedly.
Leak / Anti-Flood System Activation
E11
Washer-dryer shows E11 and does not unlock the door at the end of the cycle.
Door Unlock Timeout
E12
Washer-dryer shows E12 and stops during spin; drum may be heavily loaded or unbalanced.
Unbalanced Load / Spin Protection Fault
E13
Washer-dryer displays E13 and does not proceed to spin; water level may be incorrect.
Water Level Detection Error
E14
Washer-dryer shows E14 and stops; often associated with overheating during drying.
Dryer Overheating / Safety Thermostat Trip
E15
Washer-dryer shows E15 and will not start; often after a power surge or outage.
Control Board Communication / EEPROM Error
E16
Washer-dryer shows E16 and stops; often related to door open detection during cycle.
Door Open Signal During Operation
E17
Washer-dryer shows E17 and stops filling; often associated with hot water or second inlet valve on certain models.
Secondary Water Inlet Valve Fault
E18
Washer-dryer shows E18 and stops; drain time exceeded but some water may have left the drum.
Slow Drain / Partial Blockage
E19
Washer-dryer shows E19; often related to detergent dispenser or water distribution issues.
Dispenser Valve / Water Distribution Fault
E20
Washer-dryer shows E20 and may stop during high-speed spin.
Excessive Vibration / Suspension Fault
E21
Washer-dryer shows E21; motor attempts to start but stops immediately.
Motor Tachometer / Speed Feedback Fault
E22
Washer-dryer shows E22; often associated with NTC sensor errors in wash cycle.
Wash Temperature Sensor (NTC) Fault
E23
Washer-dryer shows E23; drain pump may not run at all.
Drain Pump Triac / Control Fault
E24
Washer-dryer shows E24; often related to dryer fan or airflow monitoring.
Dryer Fan / Airflow Fault
E25
Washer-dryer shows E25; may be associated with communication between main board and dryer module.
Dryer Module Communication Fault
Symptom
Drying function leaves clothes damp or only slightly warm at the end of the cycle.
Insufficient Drying / Low Heat
Symptom
Washer-dryer combo leaks water from the front during wash or rinse, but no error code is displayed.
Door Gasket / Front Leak
Symptom
Washer-dryer does not start at all; no lights or display, as if completely dead.
No Power / Main Supply Fault
Symptom
Washer-dryer door will not open at the end of the cycle, but no error code is shown.
Door Stuck / Mechanical Jam
Symptom
Washer-dryer drum does not turn at all in wash or spin, but the machine fills and drains normally.
Drive System Failure
Symptom
Washer-dryer emits a grinding or rumbling noise during spin that is getting progressively worse.
Drum Bearing Wear
Symptom
Washer-dryer has a persistent bad smell inside the drum or during drying.
Biofilm / Residue Build-Up
Symptom
Washer-dryer leaks from the rear or underneath during wash, no error code shown.
Internal Hose or Pump Leak
Symptom
Washer-dryer leaves clothes very wet at the end of the cycle, even though it appears to have spun.
Poor Spin Performance
Symptom
Washer-dryer leaves laundry with detergent residues or not properly rinsed.
Poor Rinsing / Detergent Dispensing Issue
Symptom
Washer-dryer makes a loud clicking or rattling noise during wash or spin, as if something is loose inside the drum.
Foreign Object in Drum or Pump
Symptom
Washer-dryer makes loud banging or knocking noises during spin, but completes the cycle.
Excessive Vibration / Suspension Wear
Symptom
Washer-dryer powers on but buttons or dial do not respond, or programs cannot be selected.
User Interface / Control Panel Fault
Symptom
Washer-dryer produces a high-pitched squealing noise when the drum turns.
Drive Belt or Pulley Noise
Symptom
Washer-dryer shows condensation or steam around the control panel or door during drying, with slight moisture escaping.
Door Seal / Venting Inefficiency in Drying
Symptom
Washer-dryer takes much longer than the displayed time to complete cycles, especially when drying.
Extended Cycle Time / Sensor Drying Inefficiency
Symptom
Washer-dryer trips the household circuit breaker or RCD during operation.
Electrical Short or Earth Leakage
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer will not start a program; display shows E01 immediately after pressing Start.
|
Door Lock Failure | View Details |
| E02 |
Washer-dryer does not fill with water; E02 appears shortly after program start.
|
Water Inlet Fault | View Details |
| E03 |
Washer-dryer does not drain; water remains in drum and E03 is displayed.
|
Drain Pump or Drainage Fault | View Details |
| E04 |
Washer-dryer overfills or shows E04 with water visible in the door glass above normal level.
|
Overfill / Water Level Sensor Fault | View Details |
| E05 |
Washer-dryer does not heat during wash; cycles take unusually long and E05 appears.
|
Wash Heating Circuit Fault | View Details |
| E06 |
Washer-dryer does not spin; drum turns slowly or not at all and E06 is displayed.
|
Motor Drive Fault | View Details |
| E07 |
Washer-dryer stops mid-cycle with E07; drum may be locked and will not rotate by hand.
|
Drum Lock / Motor Jam Fault | View Details |
| E08 |
Washer-dryer shows E08 and will not start drying; washing functions may still work.
|
Dryer Heating Circuit Fault | View Details |
| E09 |
Drying performance is poor or non-existent; E09 appears near the end of the drying cycle.
|
Dryer Condenser / Moisture Sensing Fault | View Details |
| E10 |
Washer-dryer displays E10 and stops; water may be visible in the base tray or machine may have pumped out unexpectedly.
|
Leak / Anti-Flood System Activation | View Details |
| E11 |
Washer-dryer shows E11 and does not unlock the door at the end of the cycle.
|
Door Unlock Timeout | View Details |
| E12 |
Washer-dryer shows E12 and stops during spin; drum may be heavily loaded or unbalanced.
|
Unbalanced Load / Spin Protection Fault | View Details |
| E13 |
Washer-dryer displays E13 and does not proceed to spin; water level may be incorrect.
|
Water Level Detection Error | View Details |
| E14 |
Washer-dryer shows E14 and stops; often associated with overheating during drying.
|
Dryer Overheating / Safety Thermostat Trip | View Details |
| E15 |
Washer-dryer shows E15 and will not start; often after a power surge or outage.
|
Control Board Communication / EEPROM Error | View Details |
| E16 |
Washer-dryer shows E16 and stops; often related to door open detection during cycle.
|
Door Open Signal During Operation | View Details |
| E17 |
Washer-dryer shows E17 and stops filling; often associated with hot water or second inlet valve on certain models.
|
Secondary Water Inlet Valve Fault | View Details |
| E18 |
Washer-dryer shows E18 and stops; drain time exceeded but some water may have left the drum.
|
Slow Drain / Partial Blockage | View Details |
| E19 |
Washer-dryer shows E19; often related to detergent dispenser or water distribution issues.
|
Dispenser Valve / Water Distribution Fault | View Details |
| E20 |
Washer-dryer shows E20 and may stop during high-speed spin.
|
Excessive Vibration / Suspension Fault | View Details |
| E21 |
Washer-dryer shows E21; motor attempts to start but stops immediately.
|
Motor Tachometer / Speed Feedback Fault | View Details |
| E22 |
Washer-dryer shows E22; often associated with NTC sensor errors in wash cycle.
|
Wash Temperature Sensor (NTC) Fault | View Details |
| E23 |
Washer-dryer shows E23; drain pump may not run at all.
|
Drain Pump Triac / Control Fault | View Details |
| E24 |
Washer-dryer shows E24; often related to dryer fan or airflow monitoring.
|
Dryer Fan / Airflow Fault | View Details |
| E25 |
Washer-dryer shows E25; may be associated with communication between main board and dryer module.
|
Dryer Module Communication Fault | View Details |
| – |
Drying function leaves clothes damp or only slightly warm at the end of the cycle.
|
Insufficient Drying / Low Heat | View Details |
| – |
Washer-dryer combo leaks water from the front during wash or rinse, but no error code is displayed.
|
Door Gasket / Front Leak | View Details |
| – |
Washer-dryer does not start at all; no lights or display, as if completely dead.
|
No Power / Main Supply Fault | View Details |
| – |
Washer-dryer door will not open at the end of the cycle, but no error code is shown.
|
Door Stuck / Mechanical Jam | View Details |
| – |
Washer-dryer drum does not turn at all in wash or spin, but the machine fills and drains normally.
|
Drive System Failure | View Details |
| – |
Washer-dryer emits a grinding or rumbling noise during spin that is getting progressively worse.
|
Drum Bearing Wear | View Details |
| – |
Washer-dryer has a persistent bad smell inside the drum or during drying.
|
Biofilm / Residue Build-Up | View Details |
| – |
Washer-dryer leaks from the rear or underneath during wash, no error code shown.
|
Internal Hose or Pump Leak | View Details |
| – |
Washer-dryer leaves clothes very wet at the end of the cycle, even though it appears to have spun.
|
Poor Spin Performance | View Details |
| – |
Washer-dryer leaves laundry with detergent residues or not properly rinsed.
|
Poor Rinsing / Detergent Dispensing Issue | View Details |
| – |
Washer-dryer makes a loud clicking or rattling noise during wash or spin, as if something is loose inside the drum.
|
Foreign Object in Drum or Pump | View Details |
| – |
Washer-dryer makes loud banging or knocking noises during spin, but completes the cycle.
|
Excessive Vibration / Suspension Wear | View Details |
| – |
Washer-dryer powers on but buttons or dial do not respond, or programs cannot be selected.
|
User Interface / Control Panel Fault | View Details |
| – |
Washer-dryer produces a high-pitched squealing noise when the drum turns.
|
Drive Belt or Pulley Noise | View Details |
| – |
Washer-dryer shows condensation or steam around the control panel or door during drying, with slight moisture escaping.
|
Door Seal / Venting Inefficiency in Drying | View Details |
| – |
Washer-dryer takes much longer than the displayed time to complete cycles, especially when drying.
|
Extended Cycle Time / Sensor Drying Inefficiency | View Details |
| – |
Washer-dryer trips the household circuit breaker or RCD during operation.
|
Electrical Short or Earth Leakage | View Details |
No matching codes found
Advertisements