Brandt Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
D01
Washer-dryer combo will not start; display shows D01 and cycle will not begin even though the door is closed.
Door Lock Failure
D02
Washer-dryer combo stops during cycle or will not start; display shows D02, often accompanied by water remaining in the drum.
Drain Pump or Drain Circuit Fault
D03
Washer-dryer combo does not fill with water; display shows D03 shortly after starting a cycle.
Water Inlet Valve or Fill Circuit Fault
D04
Washer-dryer combo door will not unlock at end of cycle; display shows D04 and the door remains locked with clothes inside.
Door Unlock Failure
D05
Washer-dryer combo stops during wash or spin; display shows D05 and drum does not rotate.
Motor Drive Fault
D06
Washer-dryer combo shows D06 and may stop mid-cycle; often related to unbalanced load or spin issues.
Unbalanced Load / Spin Protection Fault
D07
Washer-dryer combo displays D07 and may not start or may stop unexpectedly; often associated with water level detection.
Water Level Sensor (Pressure Switch) Fault
D08
Washer-dryer combo shows D08 and will not heat water during wash cycles.
Wash Heating Circuit Fault
D09
Washer-dryer combo displays D09 and does not heat or dry clothes in drying cycles.
Dryer Heating Circuit Fault
D10
Washer-dryer combo shows D10 and may stop with water in the drum or fail to proceed to spin.
Drain Time-Out / Pump Performance Fault
D11
Washer-dryer combo displays D11 and may not start or may stop during cycle; often linked to communication between control boards (if separate motor control exists).
Control Board Communication Fault
D12
Washer-dryer combo shows D12 and may not respond correctly to program selection or may freeze mid-cycle.
User Interface / Control Panel Fault
D13
Washer-dryer combo displays D13 and may stop heating or show erratic temperature behavior during wash.
Wash Temperature Sensor (NTC) Fault
D14
Washer-dryer combo shows D14 and drying performance is poor or non-functional.
Dryer Temperature Sensor (NTC) Fault
D15
Washer-dryer combo displays D15 and may stop during drying with little or no heat.
Dryer Overheat / Safety Thermostat Trip
D16
Washer-dryer combo shows D16 and may not start or may stop with an audible click from the door area.
Door Detection / Door Switch Fault
D17
Washer-dryer combo displays D17 and may not proceed to spin or may stop unexpectedly during high-speed spin.
Spin Speed / Tachometer Fault
D18
Washer-dryer combo shows D18 and may not fill or drain correctly, sometimes accompanied by unusual water level behavior.
Water Level Calibration / Overflow Protection Fault
D19
Washer-dryer combo displays D19 and may not start drying or may stop drying prematurely.
Dryer Condenser / Moisture Detection Fault
D20
Washer-dryer combo shows D20 and may not start or may stop with no obvious mechanical issue.
General System Fault / Software Error
Symptom
Washer-dryer combo displays no error but intermittently stops and starts during spin.
Intermittent Motor Control or Load Sensing Issue
Symptom
Washer-dryer combo does not dry clothes effectively; clothes come out damp after full drying cycle.
Poor Drying Performance
Symptom
Washer-dryer combo door glass becomes extremely hot during drying.
Dryer Airflow Restriction / Overheating
Symptom
Washer-dryer combo drum does not turn at all during wash or spin, but the machine fills and drains normally.
Drive System Failure
Symptom
Washer-dryer combo drum light (if equipped) does not work, but machine otherwise operates normally.
Drum Light Failure
Symptom
Washer-dryer combo emits a burning smell during operation.
Overheating or Electrical Insulation Failure
Symptom
Washer-dryer combo emits a sewage or rotten smell during draining.
Drain System Odor
Symptom
Washer-dryer combo fills with water even when turned off, or slowly fills when not in use.
Water Inlet Valve Not Closing Properly
Symptom
Washer-dryer combo has a persistent musty or moldy odor inside the drum.
Biofilm and Mold Build-Up
Symptom
Washer-dryer combo leaks water from the front during wash or rinse cycles.
Door Seal (Gasket) Leak
Symptom
Washer-dryer combo leaks water from the rear or bottom during operation.
Internal Hose or Tub Seal Leak
Symptom
Washer-dryer combo leaves clothes very wet at the end of the cycle.
Poor Spin Performance
Symptom
Washer-dryer combo leaves detergent residues on clothes after washing.
Poor Rinsing / Detergent Dispensing Issue
Symptom
Washer-dryer combo makes loud banging or knocking noises during spin.
Suspension or Drum Support Failure
Symptom
Washer-dryer combo powers on but will not start any program; Start/Pause button unresponsive.
User Interface Input Failure
Symptom
Washer-dryer combo produces a high-pitched squealing or grinding noise when spinning.
Drum Bearing or Drive System Wear
Symptom
Washer-dryer combo takes too long to complete cycles or seems stuck on one stage.
Cycle Time Extension / Sensor Feedback Issue
Symptom
Washer-dryer combo vibrates excessively and moves across the floor during spin.
Excessive Vibration / Poor Installation
Symptom
Washer-dryer combo will not power on; no lights or display.
No Power / Power Supply Fault
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| D01 |
Washer-dryer combo will not start; display shows D01 and cycle will not begin even though the door is closed.
|
Door Lock Failure | View Details |
| D02 |
Washer-dryer combo stops during cycle or will not start; display shows D02, often accompanied by water remaining in the drum.
|
Drain Pump or Drain Circuit Fault | View Details |
| D03 |
Washer-dryer combo does not fill with water; display shows D03 shortly after starting a cycle.
|
Water Inlet Valve or Fill Circuit Fault | View Details |
| D04 |
Washer-dryer combo door will not unlock at end of cycle; display shows D04 and the door remains locked with clothes inside.
|
Door Unlock Failure | View Details |
| D05 |
Washer-dryer combo stops during wash or spin; display shows D05 and drum does not rotate.
|
Motor Drive Fault | View Details |
| D06 |
Washer-dryer combo shows D06 and may stop mid-cycle; often related to unbalanced load or spin issues.
|
Unbalanced Load / Spin Protection Fault | View Details |
| D07 |
Washer-dryer combo displays D07 and may not start or may stop unexpectedly; often associated with water level detection.
|
Water Level Sensor (Pressure Switch) Fault | View Details |
| D08 |
Washer-dryer combo shows D08 and will not heat water during wash cycles.
|
Wash Heating Circuit Fault | View Details |
| D09 |
Washer-dryer combo displays D09 and does not heat or dry clothes in drying cycles.
|
Dryer Heating Circuit Fault | View Details |
| D10 |
Washer-dryer combo shows D10 and may stop with water in the drum or fail to proceed to spin.
|
Drain Time-Out / Pump Performance Fault | View Details |
| D11 |
Washer-dryer combo displays D11 and may not start or may stop during cycle; often linked to communication between control boards (if separate motor control exists).
|
Control Board Communication Fault | View Details |
| D12 |
Washer-dryer combo shows D12 and may not respond correctly to program selection or may freeze mid-cycle.
|
User Interface / Control Panel Fault | View Details |
| D13 |
Washer-dryer combo displays D13 and may stop heating or show erratic temperature behavior during wash.
|
Wash Temperature Sensor (NTC) Fault | View Details |
| D14 |
Washer-dryer combo shows D14 and drying performance is poor or non-functional.
|
Dryer Temperature Sensor (NTC) Fault | View Details |
| D15 |
Washer-dryer combo displays D15 and may stop during drying with little or no heat.
|
Dryer Overheat / Safety Thermostat Trip | View Details |
| D16 |
Washer-dryer combo shows D16 and may not start or may stop with an audible click from the door area.
|
Door Detection / Door Switch Fault | View Details |
| D17 |
Washer-dryer combo displays D17 and may not proceed to spin or may stop unexpectedly during high-speed spin.
|
Spin Speed / Tachometer Fault | View Details |
| D18 |
Washer-dryer combo shows D18 and may not fill or drain correctly, sometimes accompanied by unusual water level behavior.
|
Water Level Calibration / Overflow Protection Fault | View Details |
| D19 |
Washer-dryer combo displays D19 and may not start drying or may stop drying prematurely.
|
Dryer Condenser / Moisture Detection Fault | View Details |
| D20 |
Washer-dryer combo shows D20 and may not start or may stop with no obvious mechanical issue.
|
General System Fault / Software Error | View Details |
| – |
Washer-dryer combo displays no error but intermittently stops and starts during spin.
|
Intermittent Motor Control or Load Sensing Issue | View Details |
| – |
Washer-dryer combo does not dry clothes effectively; clothes come out damp after full drying cycle.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer combo door glass becomes extremely hot during drying.
|
Dryer Airflow Restriction / Overheating | View Details |
| – |
Washer-dryer combo drum does not turn at all during wash or spin, but the machine fills and drains normally.
|
Drive System Failure | View Details |
| – |
Washer-dryer combo drum light (if equipped) does not work, but machine otherwise operates normally.
|
Drum Light Failure | View Details |
| – |
Washer-dryer combo emits a burning smell during operation.
|
Overheating or Electrical Insulation Failure | View Details |
| – |
Washer-dryer combo emits a sewage or rotten smell during draining.
|
Drain System Odor | View Details |
| – |
Washer-dryer combo fills with water even when turned off, or slowly fills when not in use.
|
Water Inlet Valve Not Closing Properly | View Details |
| – |
Washer-dryer combo has a persistent musty or moldy odor inside the drum.
|
Biofilm and Mold Build-Up | View Details |
| – |
Washer-dryer combo leaks water from the front during wash or rinse cycles.
|
Door Seal (Gasket) Leak | View Details |
| – |
Washer-dryer combo leaks water from the rear or bottom during operation.
|
Internal Hose or Tub Seal Leak | View Details |
| – |
Washer-dryer combo leaves clothes very wet at the end of the cycle.
|
Poor Spin Performance | View Details |
| – |
Washer-dryer combo leaves detergent residues on clothes after washing.
|
Poor Rinsing / Detergent Dispensing Issue | View Details |
| – |
Washer-dryer combo makes loud banging or knocking noises during spin.
|
Suspension or Drum Support Failure | View Details |
| – |
Washer-dryer combo powers on but will not start any program; Start/Pause button unresponsive.
|
User Interface Input Failure | View Details |
| – |
Washer-dryer combo produces a high-pitched squealing or grinding noise when spinning.
|
Drum Bearing or Drive System Wear | View Details |
| – |
Washer-dryer combo takes too long to complete cycles or seems stuck on one stage.
|
Cycle Time Extension / Sensor Feedback Issue | View Details |
| – |
Washer-dryer combo vibrates excessively and moves across the floor during spin.
|
Excessive Vibration / Poor Installation | View Details |
| – |
Washer-dryer combo will not power on; no lights or display.
|
No Power / Power Supply Fault | View Details |
No matching codes found
Advertisements