Avanti
Avanti Wine Coolers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
dF
Display alternates between dF and temperature; unit may pause cooling periodically.
Defrost Mode Indication / Defrost Cycle Active
door
Display shows 'door' or a door icon and an alarm sounds even when the door is closed.
Door Switch or Door Ajar Sensor Fault
E1
Wine cooler display shows E1 and cabinet is not cooling or only slightly cool.
Cabinet Temperature Sensor (Thermistor) Failure
E2
Wine cooler shows E2 and may run continuously or not cool correctly.
Evaporator Temperature Sensor Failure
E3
Display shows E3 and temperature readings are erratic or inaccurate.
Ambient (Room) Temperature Sensor Failure
E4
Wine cooler beeps and shows E4; unit may shut down or run erratically.
Defrost Sensor or Defrost Circuit Failure
E5
Display shows E5 and compressor or cooling module does not start.
Compressor Start/Overload Protection Fault
E6
Wine cooler shows E6 and interior fan does not run or runs intermittently.
Evaporator Fan Motor Fault
E7
Dual-zone Avanti wine cooler shows E7 and one or both zones do not maintain set temperature.
Dual-Zone Communication or Zone Sensor Fault
E8
Display shows E8 and compressor or Peltier module shuts down shortly after starting.
High Temperature or Overheat Protection Fault
E9
Wine cooler shows E9 and interior light or display may flicker; cooling may stop.
Low Voltage or Power Supply Fault
EE
Display shows EE or all segments flash; cooler does not respond to buttons.
Control Board or Display Panel Communication Error
HI
Display shows HI or H1 and unit may run continuously without reaching set temperature.
Temperature Display Over-Range / Sensor Fault
LO
Display shows LO or L0 and interior temperature is much warmer than indicated.
Temperature Display Under-Range / Sensor Calibration Fault
Symptom
Buttons on the control panel do not respond or respond intermittently.
Keypad / Touch Control Failure
Symptom
Clicking sound every few minutes; compressor tries to start but shuts off quickly.
Compressor Hard Start / Overload Tripping
Symptom
Condensation or moisture forming on the outside of the door or cabinet.
Exterior Condensation / High Humidity
Symptom
Display is blank or very dim, but the cooler still runs.
Display Backlight or Display Power Failure
Symptom
Display shows temperature but does not change even as the interior warms or cools.
Stuck or Unresponsive Temperature Sensor
Symptom
Door does not close properly or pops open slightly after closing.
Door Alignment / Hinge or Gasket Problem
Symptom
Excessive frost or ice buildup on the back wall or around the evaporator.
Frost Accumulation / Defrost System Failure
Symptom
Interior fan runs but there is little or no cool air; compressor or Peltier is off.
Cooling Output Not Engaging
Symptom
Interior light does not turn on when door is opened, but cooling works normally.
Interior Light Circuit Failure
Symptom
Interior light stays on even when the door is closed, causing overheating.
Stuck Door Switch or Light Control Fault
Symptom
Interior temperature fluctuates widely when the room temperature changes.
Poor Insulation or Ambient Compensation Issue
Symptom
Loud humming, buzzing, or rattling noise during operation.
Excessive Operational Noise / Vibration
Symptom
Lower zone cools but upper zone is warm (dual-zone model).
Upper Zone Cooling Failure in Dual-Zone System
Symptom
Strong chemical or burning smell coming from the wine cooler.
Overheating Component or Electrical Burn
Symptom
Thermoelectric (Peltier) Avanti wine cooler is warm on both sides; no temperature difference.
Peltier Module Failure
Symptom
Unit trips the household circuit breaker or GFCI outlet when it starts.
Electrical Short or Ground Fault
Symptom
Unit vibrates excessively and can be felt through nearby cabinets or countertop.
Mechanical Vibration / Mounting Issue
Symptom
Upper zone cools but lower zone is warm (dual-zone model).
Single-Zone Cooling Failure in Dual-Zone System
Symptom
Water pooling at the bottom of the wine cooler or leaking onto the floor.
Drainage Problem / Condensate Leak
Symptom
Wine cooler cycles on and off frequently, with large temperature swings.
Short Cycling / Poor Temperature Control
Symptom
Wine cooler interior is too cold; bottles or labels show signs of freezing.
Overcooling / Thermostat or Sensor Out of Calibration
Symptom
Wine cooler not cooling at all; interior at room temperature and compressor or Peltier module never starts.
No Cooling / Power or Control Failure
Symptom
Wine cooler runs but does not get cold enough; temperature stays above setpoint.
Insufficient Cooling / Loss of Refrigeration Capacity
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| dF |
Display alternates between dF and temperature; unit may pause cooling periodically.
|
Defrost Mode Indication / Defrost Cycle Active | View Details |
| door |
Display shows 'door' or a door icon and an alarm sounds even when the door is closed.
|
Door Switch or Door Ajar Sensor Fault | View Details |
| E1 |
Wine cooler display shows E1 and cabinet is not cooling or only slightly cool.
|
Cabinet Temperature Sensor (Thermistor) Failure | View Details |
| E2 |
Wine cooler shows E2 and may run continuously or not cool correctly.
|
Evaporator Temperature Sensor Failure | View Details |
| E3 |
Display shows E3 and temperature readings are erratic or inaccurate.
|
Ambient (Room) Temperature Sensor Failure | View Details |
| E4 |
Wine cooler beeps and shows E4; unit may shut down or run erratically.
|
Defrost Sensor or Defrost Circuit Failure | View Details |
| E5 |
Display shows E5 and compressor or cooling module does not start.
|
Compressor Start/Overload Protection Fault | View Details |
| E6 |
Wine cooler shows E6 and interior fan does not run or runs intermittently.
|
Evaporator Fan Motor Fault | View Details |
| E7 |
Dual-zone Avanti wine cooler shows E7 and one or both zones do not maintain set temperature.
|
Dual-Zone Communication or Zone Sensor Fault | View Details |
| E8 |
Display shows E8 and compressor or Peltier module shuts down shortly after starting.
|
High Temperature or Overheat Protection Fault | View Details |
| E9 |
Wine cooler shows E9 and interior light or display may flicker; cooling may stop.
|
Low Voltage or Power Supply Fault | View Details |
| EE |
Display shows EE or all segments flash; cooler does not respond to buttons.
|
Control Board or Display Panel Communication Error | View Details |
| HI |
Display shows HI or H1 and unit may run continuously without reaching set temperature.
|
Temperature Display Over-Range / Sensor Fault | View Details |
| LO |
Display shows LO or L0 and interior temperature is much warmer than indicated.
|
Temperature Display Under-Range / Sensor Calibration Fault | View Details |
| – |
Buttons on the control panel do not respond or respond intermittently.
|
Keypad / Touch Control Failure | View Details |
| – |
Clicking sound every few minutes; compressor tries to start but shuts off quickly.
|
Compressor Hard Start / Overload Tripping | View Details |
| – |
Condensation or moisture forming on the outside of the door or cabinet.
|
Exterior Condensation / High Humidity | View Details |
| – |
Display is blank or very dim, but the cooler still runs.
|
Display Backlight or Display Power Failure | View Details |
| – |
Display shows temperature but does not change even as the interior warms or cools.
|
Stuck or Unresponsive Temperature Sensor | View Details |
| – |
Door does not close properly or pops open slightly after closing.
|
Door Alignment / Hinge or Gasket Problem | View Details |
| – |
Excessive frost or ice buildup on the back wall or around the evaporator.
|
Frost Accumulation / Defrost System Failure | View Details |
| – |
Interior fan runs but there is little or no cool air; compressor or Peltier is off.
|
Cooling Output Not Engaging | View Details |
| – |
Interior light does not turn on when door is opened, but cooling works normally.
|
Interior Light Circuit Failure | View Details |
| – |
Interior light stays on even when the door is closed, causing overheating.
|
Stuck Door Switch or Light Control Fault | View Details |
| – |
Interior temperature fluctuates widely when the room temperature changes.
|
Poor Insulation or Ambient Compensation Issue | View Details |
| – |
Loud humming, buzzing, or rattling noise during operation.
|
Excessive Operational Noise / Vibration | View Details |
| – |
Lower zone cools but upper zone is warm (dual-zone model).
|
Upper Zone Cooling Failure in Dual-Zone System | View Details |
| – |
Strong chemical or burning smell coming from the wine cooler.
|
Overheating Component or Electrical Burn | View Details |
| – |
Thermoelectric (Peltier) Avanti wine cooler is warm on both sides; no temperature difference.
|
Peltier Module Failure | View Details |
| – |
Unit trips the household circuit breaker or GFCI outlet when it starts.
|
Electrical Short or Ground Fault | View Details |
| – |
Unit vibrates excessively and can be felt through nearby cabinets or countertop.
|
Mechanical Vibration / Mounting Issue | View Details |
| – |
Upper zone cools but lower zone is warm (dual-zone model).
|
Single-Zone Cooling Failure in Dual-Zone System | View Details |
| – |
Water pooling at the bottom of the wine cooler or leaking onto the floor.
|
Drainage Problem / Condensate Leak | View Details |
| – |
Wine cooler cycles on and off frequently, with large temperature swings.
|
Short Cycling / Poor Temperature Control | View Details |
| – |
Wine cooler interior is too cold; bottles or labels show signs of freezing.
|
Overcooling / Thermostat or Sensor Out of Calibration | View Details |
| – |
Wine cooler not cooling at all; interior at room temperature and compressor or Peltier module never starts.
|
No Cooling / Power or Control Failure | View Details |
| – |
Wine cooler runs but does not get cold enough; temperature stays above setpoint.
|
Insufficient Cooling / Loss of Refrigeration Capacity | View Details |
No matching codes found
Advertisements