Avanti
Avanti Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Washer-dryer combo will not fill with water; cycle starts then quickly pauses and displays E1.
Water Inlet Timeout / No Fill Detected
E10
Washer-dryer combo displays E10 and will not start; control panel may be unresponsive or partially functional.
Communication Error Between Control Panel and Main PCB
E11
Washer-dryer combo shows E11 and stops; drain pump may run continuously or not at all.
Drain Sensor / Pump Feedback Error
E12
Washer-dryer combo displays E12 during drying; drum may turn but there is little or no heat.
Dryer Temperature Sensor (NTC) Error
E13
Washer-dryer combo shows E13 and stops; often associated with overheating during drying.
Dryer Overheat / High-Limit Thermostat Trip
E14
Washer-dryer combo displays E14; unit may not respond correctly to selected programs.
Program Selector / Encoder Error
E15
Washer-dryer combo shows E15 and will not start; often after a power surge or outage.
EEPROM / Control Memory Error
E16
Washer-dryer combo displays E16; water may be seen in the base pan or the unit may stop unexpectedly.
Leak Sensor / Flood Protection Activated
E17
Washer-dryer combo shows E17; often associated with very long fill times or low water pressure.
Low Water Pressure / Fill Flow Error
E18
Washer-dryer combo displays E18; drum may not reach proper spin speed and clothes come out very wet.
Spin Speed / RPM Sensor Error
E19
Washer-dryer combo shows E19; unit may stop during heating or show erratic temperature behavior.
Water Heating System Error (if equipped with internal heater)
E2
Washer-dryer combo does not drain water; cycle stops with water left in drum and displays E2.
Drain Pump Failure / Drain Timeout
E20
Washer-dryer combo displays E20; often associated with door not unlocking at end of cycle.
Door Unlock Failure
E3
Washer-dryer combo drum does not spin or tumble; unit may fill and drain but stops with E3 on display.
Motor Drive Fault / No Spin Detected
E4
Washer-dryer combo displays E4 and stops during wash or spin; drum may be banging or not reaching full speed.
Unbalanced Load / Out-of-Balance Detection
E5
Washer-dryer combo stops heating during dry cycle and shows E5; clothes remain wet and cold.
Dryer Heating Circuit Failure
E6
Washer-dryer combo displays E6 and will not start or complete a cycle; door may not lock properly.
Door Lock / Door Switch Failure
E7
Washer-dryer combo shows E7 and stops mid-cycle; water level appears incorrect (either overfilling or underfilling).
Water Level Sensor / Pressure Switch Error
E8
Washer-dryer combo displays E8 and stops; drum may not rotate correctly or may be noisy.
Hall Sensor / Motor Tachometer Error
E9
Washer-dryer combo shows E9 and stops; water may be seen leaking or the unit may overfill and then drain continuously.
Overflow / Water Leak Detection
Symptom
Washer-dryer combo control panel buttons are unresponsive or respond intermittently.
User Interface / Touchpad Failure
Symptom
Washer-dryer combo detergent drawer overflows or leaks detergent down the front of the machine.
Dispenser Drawer / Housing Blockage
Symptom
Washer-dryer combo does not drain completely; small amount of water remains in drum after cycle.
Partial Drain / Restricted Pump Flow
Symptom
Washer-dryer combo does not dry clothes effectively; clothes remain damp after full dry cycle.
Poor Drying Performance
Symptom
Washer-dryer combo door will not open at end of cycle, but no error code is shown.
Door Lock Stuck Closed
Symptom
Washer-dryer combo drum does not turn during wash or dry, but motor can be heard humming.
Drive Belt Slippage or Motor Start Failure
Symptom
Washer-dryer combo emits a burning smell during wash or dry cycles.
Overheating Component or Friction
Symptom
Washer-dryer combo emits a grinding or rumbling noise, especially at high spin speeds.
Drum Bearing or Spider Arm Failure
Symptom
Washer-dryer combo has a musty or moldy odor inside the drum or from the door gasket.
Biofilm and Mold Build-Up
Symptom
Washer-dryer combo intermittently trips the household circuit breaker or GFCI outlet.
Electrical Short or Ground Fault
Symptom
Washer-dryer combo leaks water from the front door area during wash or rinse.
Door Gasket / Boot Seal Leak
Symptom
Washer-dryer combo leaks water from the rear or bottom during wash or drain.
Internal Hose or Pump Leak
Symptom
Washer-dryer combo leaves clothes very wet at the end of cycle, even though it appears to spin.
Insufficient Spin Extraction
Symptom
Washer-dryer combo leaves visible detergent or fabric softener residue on clothes.
Poor Rinsing / Dispenser Performance
Symptom
Washer-dryer combo makes loud banging or knocking noises during spin.
Suspension / Shock Absorber Wear
Symptom
Washer-dryer combo produces a clicking or rattling noise from the pump area during drain.
Foreign Object in Drain Pump
Symptom
Washer-dryer combo produces a high-pitched squeal or screech when spinning or tumbling.
Drive Belt or Drum Support Friction
Symptom
Washer-dryer combo takes excessively long to dry; cycle times seem much longer than normal.
Restricted Airflow / Moisture Sensor Issue
Symptom
Washer-dryer combo vibrates excessively or "walks" across the floor during spin.
Out-of-Balance Operation / Installation Issue
Symptom
Washer-dryer combo will not power on at all; no lights or display, but outlet has power.
Main Power Supply / Line Filter Failure
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Washer-dryer combo will not fill with water; cycle starts then quickly pauses and displays E1.
|
Water Inlet Timeout / No Fill Detected | View Details |
| E10 |
Washer-dryer combo displays E10 and will not start; control panel may be unresponsive or partially functional.
|
Communication Error Between Control Panel and Main PCB | View Details |
| E11 |
Washer-dryer combo shows E11 and stops; drain pump may run continuously or not at all.
|
Drain Sensor / Pump Feedback Error | View Details |
| E12 |
Washer-dryer combo displays E12 during drying; drum may turn but there is little or no heat.
|
Dryer Temperature Sensor (NTC) Error | View Details |
| E13 |
Washer-dryer combo shows E13 and stops; often associated with overheating during drying.
|
Dryer Overheat / High-Limit Thermostat Trip | View Details |
| E14 |
Washer-dryer combo displays E14; unit may not respond correctly to selected programs.
|
Program Selector / Encoder Error | View Details |
| E15 |
Washer-dryer combo shows E15 and will not start; often after a power surge or outage.
|
EEPROM / Control Memory Error | View Details |
| E16 |
Washer-dryer combo displays E16; water may be seen in the base pan or the unit may stop unexpectedly.
|
Leak Sensor / Flood Protection Activated | View Details |
| E17 |
Washer-dryer combo shows E17; often associated with very long fill times or low water pressure.
|
Low Water Pressure / Fill Flow Error | View Details |
| E18 |
Washer-dryer combo displays E18; drum may not reach proper spin speed and clothes come out very wet.
|
Spin Speed / RPM Sensor Error | View Details |
| E19 |
Washer-dryer combo shows E19; unit may stop during heating or show erratic temperature behavior.
|
Water Heating System Error (if equipped with internal heater) | View Details |
| E2 |
Washer-dryer combo does not drain water; cycle stops with water left in drum and displays E2.
|
Drain Pump Failure / Drain Timeout | View Details |
| E20 |
Washer-dryer combo displays E20; often associated with door not unlocking at end of cycle.
|
Door Unlock Failure | View Details |
| E3 |
Washer-dryer combo drum does not spin or tumble; unit may fill and drain but stops with E3 on display.
|
Motor Drive Fault / No Spin Detected | View Details |
| E4 |
Washer-dryer combo displays E4 and stops during wash or spin; drum may be banging or not reaching full speed.
|
Unbalanced Load / Out-of-Balance Detection | View Details |
| E5 |
Washer-dryer combo stops heating during dry cycle and shows E5; clothes remain wet and cold.
|
Dryer Heating Circuit Failure | View Details |
| E6 |
Washer-dryer combo displays E6 and will not start or complete a cycle; door may not lock properly.
|
Door Lock / Door Switch Failure | View Details |
| E7 |
Washer-dryer combo shows E7 and stops mid-cycle; water level appears incorrect (either overfilling or underfilling).
|
Water Level Sensor / Pressure Switch Error | View Details |
| E8 |
Washer-dryer combo displays E8 and stops; drum may not rotate correctly or may be noisy.
|
Hall Sensor / Motor Tachometer Error | View Details |
| E9 |
Washer-dryer combo shows E9 and stops; water may be seen leaking or the unit may overfill and then drain continuously.
|
Overflow / Water Leak Detection | View Details |
| – |
Washer-dryer combo control panel buttons are unresponsive or respond intermittently.
|
User Interface / Touchpad Failure | View Details |
| – |
Washer-dryer combo detergent drawer overflows or leaks detergent down the front of the machine.
|
Dispenser Drawer / Housing Blockage | View Details |
| – |
Washer-dryer combo does not drain completely; small amount of water remains in drum after cycle.
|
Partial Drain / Restricted Pump Flow | View Details |
| – |
Washer-dryer combo does not dry clothes effectively; clothes remain damp after full dry cycle.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer combo door will not open at end of cycle, but no error code is shown.
|
Door Lock Stuck Closed | View Details |
| – |
Washer-dryer combo drum does not turn during wash or dry, but motor can be heard humming.
|
Drive Belt Slippage or Motor Start Failure | View Details |
| – |
Washer-dryer combo emits a burning smell during wash or dry cycles.
|
Overheating Component or Friction | View Details |
| – |
Washer-dryer combo emits a grinding or rumbling noise, especially at high spin speeds.
|
Drum Bearing or Spider Arm Failure | View Details |
| – |
Washer-dryer combo has a musty or moldy odor inside the drum or from the door gasket.
|
Biofilm and Mold Build-Up | View Details |
| – |
Washer-dryer combo intermittently trips the household circuit breaker or GFCI outlet.
|
Electrical Short or Ground Fault | View Details |
| – |
Washer-dryer combo leaks water from the front door area during wash or rinse.
|
Door Gasket / Boot Seal Leak | View Details |
| – |
Washer-dryer combo leaks water from the rear or bottom during wash or drain.
|
Internal Hose or Pump Leak | View Details |
| – |
Washer-dryer combo leaves clothes very wet at the end of cycle, even though it appears to spin.
|
Insufficient Spin Extraction | View Details |
| – |
Washer-dryer combo leaves visible detergent or fabric softener residue on clothes.
|
Poor Rinsing / Dispenser Performance | View Details |
| – |
Washer-dryer combo makes loud banging or knocking noises during spin.
|
Suspension / Shock Absorber Wear | View Details |
| – |
Washer-dryer combo produces a clicking or rattling noise from the pump area during drain.
|
Foreign Object in Drain Pump | View Details |
| – |
Washer-dryer combo produces a high-pitched squeal or screech when spinning or tumbling.
|
Drive Belt or Drum Support Friction | View Details |
| – |
Washer-dryer combo takes excessively long to dry; cycle times seem much longer than normal.
|
Restricted Airflow / Moisture Sensor Issue | View Details |
| – |
Washer-dryer combo vibrates excessively or "walks" across the floor during spin.
|
Out-of-Balance Operation / Installation Issue | View Details |
| – |
Washer-dryer combo will not power on at all; no lights or display, but outlet has power.
|
Main Power Supply / Line Filter Failure | View Details |
No matching codes found
Advertisements