KitchenAid Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
F01
Washer-dryer combo will not start any cycle; display shows F01 and beeps.
Main Control Board Failure
F02
Cycle stops and display shows F02; washer-dryer does not drain or drains very slowly.
Long Drain Fault
F03
Washer-dryer stops mid-cycle with F03 displayed; may not advance or may shut down unexpectedly.
Temperature Sensor (NTC) Error
F05
Washer-dryer stops with F05; may not fill or may overfill slightly before stopping.
Water Temperature or Pressure Sensor Fault (model-dependent)
F06
Washer-dryer will not spin or tumble; F06 appears on the display.
Motor Tachometer or Motor Drive Fault
F07
Washer-dryer stops heating during wash or dry; F07 displayed.
Heater Relay Stuck or Heating Circuit Fault
F08
Washer-dryer shows F08 and may not fill properly; sometimes fills continuously or not at all.
Water Level / Overflow Fault
F09
F09 appears and the washer-dryer may stop with water still in the drum.
Overflow Condition Detected
F10
Washer-dryer displays F10 and may not start or may stop shortly after starting.
Communication Error Between Control Boards (if separate motor/control modules are used)
F11
F11 appears; washer-dryer may stop mid-cycle and not respond to commands.
Serial Communication Error
F13
Drying function fails and F13 is displayed; washer cycles may complete but clothes do not dry.
Dryer Fan or Drying System Fault
F20
Washer-dryer displays F20; unit does not fill or fills very slowly.
No Water Detected / Fill Fault
F21
Washer-dryer stops with water in the drum and shows F21; drain cycle takes too long or fails.
Long Drain Time
F22
Door will not lock; cycle will not start and F22 is displayed.
Door Lock Error
F23
Door remains locked at end of cycle; F23 may be displayed and the door cannot be opened.
Door Unlock Error
F24
F24 appears; washer-dryer may stop heating water or may abort cycle early.
Water Temperature Sensor Out of Range
F25
Washer-dryer shows F25; spin performance is poor or unit will not reach high spin speed.
Drum Speed Sensor / Tachometer Error
F26
F26 displayed; washer-dryer may not respond correctly to door open/close, or may not start.
Door Switch Input Error
F27
F27 appears; washer-dryer may overfill or underfill and then stop.
Water Level Sensor Range/Calibration Error
F28
F28 displayed; washer-dryer may not start or may freeze mid-cycle.
Serial Communication Error (UI to CCU)
F29
F29 appears; door may not lock or unlock correctly and cycle will not start.
Door Lock Mechanism Error
F30
F30 displayed; washer-dryer may not detect correct water level and may stop.
Dispenser or Water Level System Fault (model-dependent)
F31
F31 appears; washer-dryer may not spin correctly or may stop with an unbalanced load.
Motor Control or Speed Sensing Fault
F32
F32 displayed; washer-dryer may not detect correct water level and may abort cycle.
Pressure Switch Failure
F33
F33 appears; washer-dryer may not heat water or may stop during heating phase.
Heater Circuit Error
F34
F34 displayed; washer-dryer may not start and may indicate a door-related fault.
Door Locking System Error
F35
F35 appears; washer-dryer may not fill correctly and may stop early in the cycle.
Analog Pressure Sensor Error (if equipped)
F36
F36 displayed; washer-dryer may not start or may stop unexpectedly.
Control Board Hardware Fault
F37
F37 appears; washer-dryer may not heat water properly.
Temperature Sensor Short Circuit
F38
F38 displayed; washer-dryer may not heat water or may abort cycle.
Temperature Sensor Open Circuit
F40
F40 appears; washer-dryer may not start or may shut down shortly after starting.
Overvoltage / Undervoltage or Power Supply Error
Symptom
Control panel buttons are unresponsive or only some buttons work intermittently.
User Interface Keypad Failure
Symptom
Detergent or softener remains in the dispenser drawer after the cycle.
Dispenser Water Flow or Siphon Issue
Symptom
Grinding or rumbling noise during spin that gets louder over time.
Drum Bearing Failure
Symptom
Washer-dryer combo leaks water from the front during wash or rinse cycles.
Door Boot (Bellow) Seal Leak
Symptom
Washer-dryer does not drain completely; clothes remain wet and water is left in the drum.
Partial Drain / Pump Performance Issue
Symptom
Washer-dryer does not dry clothes effectively; clothes come out damp after full dry cycle.
Poor Drying Performance
Symptom
Washer-dryer door will not open at the end of the cycle, but no error code is shown.
Door Lock Stuck Closed
Symptom
Washer-dryer drum does not turn during wash or spin, but the unit powers on.
Drive System Failure
Symptom
Washer-dryer emits a burning smell during operation.
Overheating Component or Belt Slippage
Symptom
Washer-dryer fills with water but will not start washing (no drum movement).
Motor or Door Lock Interlock Issue
Symptom
Washer-dryer frequently stops and restarts spin due to unbalanced load, even with normal loads.
Out-of-Balance Detection Sensitivity / Suspension Wear
Symptom
Washer-dryer has a strong musty or moldy odor inside the drum.
Biofilm and Mold Buildup
Symptom
Washer-dryer leaves clothes soaking wet at the end of the cycle, even though it appears to spin.
Poor Spin Extraction
Symptom
Washer-dryer makes loud banging or knocking noises during spin.
Suspension or Shock Absorber Wear
Symptom
Washer-dryer stops during drying cycle and shuts off due to overheating.
Dryer Overheating / Airflow Restriction
Symptom
Washer-dryer vibrates excessively or walks across the floor during spin.
Out-of-Balance or Installation Issue
Symptom
Washer-dryer will not power on at all; no lights or display.
No Power / Dead Appliance
Symptom
Water leaking from the rear or bottom of the washer-dryer during or after cycles.
Tub-to-Pump or Drain Hose Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| F01 |
Washer-dryer combo will not start any cycle; display shows F01 and beeps.
|
Main Control Board Failure | View Details |
| F02 |
Cycle stops and display shows F02; washer-dryer does not drain or drains very slowly.
|
Long Drain Fault | View Details |
| F03 |
Washer-dryer stops mid-cycle with F03 displayed; may not advance or may shut down unexpectedly.
|
Temperature Sensor (NTC) Error | View Details |
| F05 |
Washer-dryer stops with F05; may not fill or may overfill slightly before stopping.
|
Water Temperature or Pressure Sensor Fault (model-dependent) | View Details |
| F06 |
Washer-dryer will not spin or tumble; F06 appears on the display.
|
Motor Tachometer or Motor Drive Fault | View Details |
| F07 |
Washer-dryer stops heating during wash or dry; F07 displayed.
|
Heater Relay Stuck or Heating Circuit Fault | View Details |
| F08 |
Washer-dryer shows F08 and may not fill properly; sometimes fills continuously or not at all.
|
Water Level / Overflow Fault | View Details |
| F09 |
F09 appears and the washer-dryer may stop with water still in the drum.
|
Overflow Condition Detected | View Details |
| F10 |
Washer-dryer displays F10 and may not start or may stop shortly after starting.
|
Communication Error Between Control Boards (if separate motor/control modules are used) | View Details |
| F11 |
F11 appears; washer-dryer may stop mid-cycle and not respond to commands.
|
Serial Communication Error | View Details |
| F13 |
Drying function fails and F13 is displayed; washer cycles may complete but clothes do not dry.
|
Dryer Fan or Drying System Fault | View Details |
| F20 |
Washer-dryer displays F20; unit does not fill or fills very slowly.
|
No Water Detected / Fill Fault | View Details |
| F21 |
Washer-dryer stops with water in the drum and shows F21; drain cycle takes too long or fails.
|
Long Drain Time | View Details |
| F22 |
Door will not lock; cycle will not start and F22 is displayed.
|
Door Lock Error | View Details |
| F23 |
Door remains locked at end of cycle; F23 may be displayed and the door cannot be opened.
|
Door Unlock Error | View Details |
| F24 |
F24 appears; washer-dryer may stop heating water or may abort cycle early.
|
Water Temperature Sensor Out of Range | View Details |
| F25 |
Washer-dryer shows F25; spin performance is poor or unit will not reach high spin speed.
|
Drum Speed Sensor / Tachometer Error | View Details |
| F26 |
F26 displayed; washer-dryer may not respond correctly to door open/close, or may not start.
|
Door Switch Input Error | View Details |
| F27 |
F27 appears; washer-dryer may overfill or underfill and then stop.
|
Water Level Sensor Range/Calibration Error | View Details |
| F28 |
F28 displayed; washer-dryer may not start or may freeze mid-cycle.
|
Serial Communication Error (UI to CCU) | View Details |
| F29 |
F29 appears; door may not lock or unlock correctly and cycle will not start.
|
Door Lock Mechanism Error | View Details |
| F30 |
F30 displayed; washer-dryer may not detect correct water level and may stop.
|
Dispenser or Water Level System Fault (model-dependent) | View Details |
| F31 |
F31 appears; washer-dryer may not spin correctly or may stop with an unbalanced load.
|
Motor Control or Speed Sensing Fault | View Details |
| F32 |
F32 displayed; washer-dryer may not detect correct water level and may abort cycle.
|
Pressure Switch Failure | View Details |
| F33 |
F33 appears; washer-dryer may not heat water or may stop during heating phase.
|
Heater Circuit Error | View Details |
| F34 |
F34 displayed; washer-dryer may not start and may indicate a door-related fault.
|
Door Locking System Error | View Details |
| F35 |
F35 appears; washer-dryer may not fill correctly and may stop early in the cycle.
|
Analog Pressure Sensor Error (if equipped) | View Details |
| F36 |
F36 displayed; washer-dryer may not start or may stop unexpectedly.
|
Control Board Hardware Fault | View Details |
| F37 |
F37 appears; washer-dryer may not heat water properly.
|
Temperature Sensor Short Circuit | View Details |
| F38 |
F38 displayed; washer-dryer may not heat water or may abort cycle.
|
Temperature Sensor Open Circuit | View Details |
| F40 |
F40 appears; washer-dryer may not start or may shut down shortly after starting.
|
Overvoltage / Undervoltage or Power Supply Error | View Details |
| – |
Control panel buttons are unresponsive or only some buttons work intermittently.
|
User Interface Keypad Failure | View Details |
| – |
Detergent or softener remains in the dispenser drawer after the cycle.
|
Dispenser Water Flow or Siphon Issue | View Details |
| – |
Grinding or rumbling noise during spin that gets louder over time.
|
Drum Bearing Failure | View Details |
| – |
Washer-dryer combo leaks water from the front during wash or rinse cycles.
|
Door Boot (Bellow) Seal Leak | View Details |
| – |
Washer-dryer does not drain completely; clothes remain wet and water is left in the drum.
|
Partial Drain / Pump Performance Issue | View Details |
| – |
Washer-dryer does not dry clothes effectively; clothes come out damp after full dry cycle.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer door will not open at the end of the cycle, but no error code is shown.
|
Door Lock Stuck Closed | View Details |
| – |
Washer-dryer drum does not turn during wash or spin, but the unit powers on.
|
Drive System Failure | View Details |
| – |
Washer-dryer emits a burning smell during operation.
|
Overheating Component or Belt Slippage | View Details |
| – |
Washer-dryer fills with water but will not start washing (no drum movement).
|
Motor or Door Lock Interlock Issue | View Details |
| – |
Washer-dryer frequently stops and restarts spin due to unbalanced load, even with normal loads.
|
Out-of-Balance Detection Sensitivity / Suspension Wear | View Details |
| – |
Washer-dryer has a strong musty or moldy odor inside the drum.
|
Biofilm and Mold Buildup | View Details |
| – |
Washer-dryer leaves clothes soaking wet at the end of the cycle, even though it appears to spin.
|
Poor Spin Extraction | View Details |
| – |
Washer-dryer makes loud banging or knocking noises during spin.
|
Suspension or Shock Absorber Wear | View Details |
| – |
Washer-dryer stops during drying cycle and shuts off due to overheating.
|
Dryer Overheating / Airflow Restriction | View Details |
| – |
Washer-dryer vibrates excessively or walks across the floor during spin.
|
Out-of-Balance or Installation Issue | View Details |
| – |
Washer-dryer will not power on at all; no lights or display.
|
No Power / Dead Appliance | View Details |
| – |
Water leaking from the rear or bottom of the washer-dryer during or after cycles.
|
Tub-to-Pump or Drain Hose Leak | View Details |
No matching codes found
Advertisements