Stoves
Stoves Dryers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Dryer will not start, display shows E01 shortly after pressing Start
Door Lock / Door Switch Fault
E02
Dryer stops shortly after starting, E02 displayed, drum may tumble briefly then shut off
Exhaust Airflow Restriction / Overheat Protection
E03
Dryer does not heat, E03 appears on display after a few minutes of running
Heating Circuit Failure (Electric Models)
E04
Dryer runs but clothes remain damp, E04 displayed near end of cycle
Moisture Sensor / Dryness Detection Fault
E05
Dryer will not start, E05 displayed, sometimes accompanied by a relay click
Motor Start Failure / Motor Circuit Fault
E06
Dryer stops mid-cycle and displays E06, may restart after cooling
Thermal Overload / High Temperature Cut-Out
E07
Dryer drum does not turn, E07 displayed, motor can be heard running or humming
Drive Belt / Drum Drive Fault
E08
Dryer display shows E08 and unit will not start, often after a power surge or outage
Control Board Communication / Internal Control Error
E09
Dryer shows E09 and stops heating, drum may still tumble
Gas Ignition Failure (Gas Models)
E10
Dryer displays E10 and will not start, often accompanied by unresponsive buttons
User Interface / Control Panel Fault
E11
Dryer shows E11 and shuts down shortly after starting, sometimes with a burning smell
Motor Overcurrent / Motor Overload Fault
E12
Dryer displays E12 and cycle ends prematurely with clothes still damp
Exhaust Thermistor / Temperature Sensor Fault
E13
Dryer shows E13 and will not start, sometimes after moving or installing the dryer
Door Latch Alignment / Door Circuit Error
E14
Dryer displays E14 and the drum light or interior light does not work
Drum Light Circuit Fault
E15
Dryer shows E15 and will not start, often after incorrect wiring or installation (electric models)
Line Voltage / Power Supply Error
E16
Dryer displays E16 and the cycle time jumps or behaves erratically
Program / Cycle Configuration Error
E17
Dryer shows E17 and makes a loud clicking or buzzing from the control area
Heater Relay / Power Relay Fault
E18
Dryer displays E18 and the drum light flickers or the display dims intermittently
Low Voltage / Power Fluctuation Detection
E19
Dryer shows E19 and the buzzer or end-of-cycle signal does not work correctly
Buzzer / Audio Output Fault
E20
Dryer displays E20 and stops shortly after start, often with no drum movement
Drum Position / Rotation Sensor Fault (if equipped)
Symptom
Dryer control panel buttons are unresponsive or intermittent
User Interface / Touchpad Failure
Symptom
Dryer display works but interior drum light does not turn on
Drum Light Bulb / Circuit Failure
Symptom
Dryer door is difficult to open or sticks closed
Door Seal / Hinge Binding
Symptom
Dryer door will not stay closed or pops open during cycle
Door Latch / Catch Failure
Symptom
Dryer drum does not turn but a humming noise is heard
Stalled Motor / Broken Belt
Symptom
Dryer drum light stays on even when the door is closed
Door Switch Stuck Open (Light Circuit)
Symptom
Dryer drum turns but clothes come out wrinkled and very hot
Overheating / Incorrect Cycle Use
Symptom
Dryer drum turns but there is a loud squealing noise during operation
Drum Support / Idler Pulley Wear
Symptom
Dryer has a burning smell during operation
Overheating / Foreign Material on Heater
Symptom
Dryer has a musty or moldy smell on clothes after drying
Odor / Contamination in Drum and Vent
Symptom
Dryer leaks water onto the floor around the unit
Condensation / Venting Issue (Non-Condensing Models)
Symptom
Dryer leaves black or brown marks on clothing
Drum Seal / Felt Seal Contamination
Symptom
Dryer makes a loud thumping or banging noise as the drum turns
Drum Support Roller Flat Spots / Out-of-Round Drum
Symptom
Dryer powers on but will not start when Start button is pressed
Start Circuit / Control Lock Issue
Symptom
Dryer produces a scraping or grinding noise when running
Drum Glide / Front Bearing Wear
Symptom
Dryer runs but does not heat (no error code displayed)
No Heat Condition (Electric Models)
Symptom
Dryer runs but timer does not advance in automatic (sensor) cycles
Auto-Dry / Moisture Sensing Failure
Symptom
Dryer stops mid-cycle and will not restart until it cools down
Motor Overheating / Thermal Protector Tripping
Symptom
Dryer takes too long to dry clothes, but does eventually dry
Poor Drying Performance / Restricted Airflow
Symptom
Dryer timer does not advance in timed dry cycles
Timer Motor / Control Board Timing Failure
Symptom
Dryer vibrates excessively or walks across the floor during operation
Excessive Vibration / Installation Issue
Symptom
Dryer will not start at all, no lights or display
No Power / Dead Dryer
Symptom
Gas dryer runs but does not heat (no error code), igniter may glow briefly or not at all
No Heat Condition (Gas Models)
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Dryer will not start, display shows E01 shortly after pressing Start
|
Door Lock / Door Switch Fault | View Details |
| E02 |
Dryer stops shortly after starting, E02 displayed, drum may tumble briefly then shut off
|
Exhaust Airflow Restriction / Overheat Protection | View Details |
| E03 |
Dryer does not heat, E03 appears on display after a few minutes of running
|
Heating Circuit Failure (Electric Models) | View Details |
| E04 |
Dryer runs but clothes remain damp, E04 displayed near end of cycle
|
Moisture Sensor / Dryness Detection Fault | View Details |
| E05 |
Dryer will not start, E05 displayed, sometimes accompanied by a relay click
|
Motor Start Failure / Motor Circuit Fault | View Details |
| E06 |
Dryer stops mid-cycle and displays E06, may restart after cooling
|
Thermal Overload / High Temperature Cut-Out | View Details |
| E07 |
Dryer drum does not turn, E07 displayed, motor can be heard running or humming
|
Drive Belt / Drum Drive Fault | View Details |
| E08 |
Dryer display shows E08 and unit will not start, often after a power surge or outage
|
Control Board Communication / Internal Control Error | View Details |
| E09 |
Dryer shows E09 and stops heating, drum may still tumble
|
Gas Ignition Failure (Gas Models) | View Details |
| E10 |
Dryer displays E10 and will not start, often accompanied by unresponsive buttons
|
User Interface / Control Panel Fault | View Details |
| E11 |
Dryer shows E11 and shuts down shortly after starting, sometimes with a burning smell
|
Motor Overcurrent / Motor Overload Fault | View Details |
| E12 |
Dryer displays E12 and cycle ends prematurely with clothes still damp
|
Exhaust Thermistor / Temperature Sensor Fault | View Details |
| E13 |
Dryer shows E13 and will not start, sometimes after moving or installing the dryer
|
Door Latch Alignment / Door Circuit Error | View Details |
| E14 |
Dryer displays E14 and the drum light or interior light does not work
|
Drum Light Circuit Fault | View Details |
| E15 |
Dryer shows E15 and will not start, often after incorrect wiring or installation (electric models)
|
Line Voltage / Power Supply Error | View Details |
| E16 |
Dryer displays E16 and the cycle time jumps or behaves erratically
|
Program / Cycle Configuration Error | View Details |
| E17 |
Dryer shows E17 and makes a loud clicking or buzzing from the control area
|
Heater Relay / Power Relay Fault | View Details |
| E18 |
Dryer displays E18 and the drum light flickers or the display dims intermittently
|
Low Voltage / Power Fluctuation Detection | View Details |
| E19 |
Dryer shows E19 and the buzzer or end-of-cycle signal does not work correctly
|
Buzzer / Audio Output Fault | View Details |
| E20 |
Dryer displays E20 and stops shortly after start, often with no drum movement
|
Drum Position / Rotation Sensor Fault (if equipped) | View Details |
| – |
Dryer control panel buttons are unresponsive or intermittent
|
User Interface / Touchpad Failure | View Details |
| – |
Dryer display works but interior drum light does not turn on
|
Drum Light Bulb / Circuit Failure | View Details |
| – |
Dryer door is difficult to open or sticks closed
|
Door Seal / Hinge Binding | View Details |
| – |
Dryer door will not stay closed or pops open during cycle
|
Door Latch / Catch Failure | View Details |
| – |
Dryer drum does not turn but a humming noise is heard
|
Stalled Motor / Broken Belt | View Details |
| – |
Dryer drum light stays on even when the door is closed
|
Door Switch Stuck Open (Light Circuit) | View Details |
| – |
Dryer drum turns but clothes come out wrinkled and very hot
|
Overheating / Incorrect Cycle Use | View Details |
| – |
Dryer drum turns but there is a loud squealing noise during operation
|
Drum Support / Idler Pulley Wear | View Details |
| – |
Dryer has a burning smell during operation
|
Overheating / Foreign Material on Heater | View Details |
| – |
Dryer has a musty or moldy smell on clothes after drying
|
Odor / Contamination in Drum and Vent | View Details |
| – |
Dryer leaks water onto the floor around the unit
|
Condensation / Venting Issue (Non-Condensing Models) | View Details |
| – |
Dryer leaves black or brown marks on clothing
|
Drum Seal / Felt Seal Contamination | View Details |
| – |
Dryer makes a loud thumping or banging noise as the drum turns
|
Drum Support Roller Flat Spots / Out-of-Round Drum | View Details |
| – |
Dryer powers on but will not start when Start button is pressed
|
Start Circuit / Control Lock Issue | View Details |
| – |
Dryer produces a scraping or grinding noise when running
|
Drum Glide / Front Bearing Wear | View Details |
| – |
Dryer runs but does not heat (no error code displayed)
|
No Heat Condition (Electric Models) | View Details |
| – |
Dryer runs but timer does not advance in automatic (sensor) cycles
|
Auto-Dry / Moisture Sensing Failure | View Details |
| – |
Dryer stops mid-cycle and will not restart until it cools down
|
Motor Overheating / Thermal Protector Tripping | View Details |
| – |
Dryer takes too long to dry clothes, but does eventually dry
|
Poor Drying Performance / Restricted Airflow | View Details |
| – |
Dryer timer does not advance in timed dry cycles
|
Timer Motor / Control Board Timing Failure | View Details |
| – |
Dryer vibrates excessively or walks across the floor during operation
|
Excessive Vibration / Installation Issue | View Details |
| – |
Dryer will not start at all, no lights or display
|
No Power / Dead Dryer | View Details |
| – |
Gas dryer runs but does not heat (no error code), igniter may glow briefly or not at all
|
No Heat Condition (Gas Models) | View Details |
No matching codes found
Advertisements