Gorenje Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Washer-dryer will not fill with water, cycle stops shortly after start and E1 is displayed.
Water Inlet Timeout / No Fill
E10
Washer-dryer shows E10 and will not start or stops; often related to water inlet or level issues.
General Water Supply / Level Error
E11
Washer-dryer displays E11; machine may stop with water inside or fail to progress.
Drain / Pump Feedback Error
E2
Washer-dryer does not drain water, drum remains full and E2 is displayed.
Drain Pump Failure / Drain Timeout
E21
Washer-dryer shows E21 and will not spin or wash; drum does not rotate.
Motor Drive Error
E22
Washer-dryer displays E22; may be associated with door not unlocking at end of cycle.
Door Unlock Error
E3
Washer-dryer overfills or shows E3 shortly after filling, sometimes with water visible in the door seal.
Water Level Sensor / Pressure Switch Error
E30
Washer-dryer shows E30 and stops; often accompanied by water in the base tray or continuous drain pump operation.
Leak / Overflow Protection Activated
E31
Washer-dryer displays E31; may be related to drying performance or condenser system.
Condenser / Drying System Error
E4
Washer-dryer displays E4 and stops, often during spin; machine may be heavily shaking or load is off-balance.
Unbalanced Load / Motor Speed Detection Error
E40
Washer-dryer shows E40; door symbol may flash and cycle will not start.
Door Not Properly Closed
E41
Washer-dryer displays E41; door appears closed but machine still reports door error.
Door Lock Signal Error
E5
Washer-dryer does not heat water during wash; clothes come out cold and E5 is displayed.
Wash Heating Circuit Failure
E50
Washer-dryer shows E50; drum may not turn or may stop suddenly during cycle.
General Motor Error
E51
Washer-dryer displays E51; often appears immediately when trying to start a cycle.
Motor Triac Short / Motor Drive Short Circuit
E6
Drying function does not heat; laundry remains wet and cold after drying cycle, E6 appears.
Dryer Heating Circuit Failure
E60
Washer-dryer shows E60; drying or washing heating may be affected.
General Heating System Error
E61
Washer-dryer displays E61; wash water does not reach set temperature in time.
Insufficient Wash Heating
E62
Washer-dryer shows E62; water overheats or there is a risk of boiling.
Overheating / Heater Stuck On
E7
Washer-dryer displays E7 and will not start or stops mid-cycle; door may remain locked.
Door Lock / Interlock Failure
E70
Washer-dryer displays E70; temperature readings appear erratic or absent.
NTC Sensor Circuit Open/Short
E8
Washer-dryer shows E8 and stops; often associated with motor not turning or erratic drum movement.
Motor / Tachometer Feedback Error
E9
Washer-dryer displays E9 and stops; may be associated with overheating or unusual temperature behavior.
Temperature Sensor (NTC) Error
E90
Washer-dryer shows E90; machine may be unresponsive or stuck.
Communication / Configuration Error
Symptom
Detergent remains in the drawer after the wash; water overflows from the detergent compartment.
Detergent Drawer / Dispenser Blockage
Symptom
Drying cycle takes excessively long and clothes remain damp, even though no error code is shown.
Poor Drying Performance / Airflow Restriction
Symptom
Washer-dryer displays incorrect time remaining or cycles end much sooner/longer than expected.
Program Timing / Sensor Feedback Issue
Symptom
Washer-dryer does not power on at all; no lights or display, no response to buttons.
No Power / Dead Appliance
Symptom
Washer-dryer door glass becomes extremely hot during drying, more than usual.
Excessive Drying Temperature / Airflow Restriction
Symptom
Washer-dryer drum does not turn during wash or dry, but you can hear humming or water filling.
Drum Not Turning / Drive Failure
Symptom
Washer-dryer emits a burning smell or hot plastic odor during operation.
Overheating / Electrical or Mechanical Friction
Symptom
Washer-dryer fills and washes but will not spin; clothes remain very wet at end of cycle.
No Spin / Spin Inhibition
Symptom
Washer-dryer is very noisy during spin; loud rumbling or grinding sound from rear of machine.
Drum Bearing Wear / Failure
Symptom
Washer-dryer leaves visible detergent or white streaks on clothes after washing.
Poor Rinsing / Detergent Residue
Symptom
Washer-dryer makes a loud banging or knocking noise during spin; machine may move or "walk".
Excessive Vibration / Suspension Fault
Symptom
Washer-dryer powers on but will not start any program; Start button unresponsive or program cancels immediately.
User Interface / Control Lock or Program Start Inhibition
Symptom
Washer-dryer produces a musty or moldy smell; clothes smell unpleasant after washing or drying.
Biofilm / Mold Build-up in Drum and Hoses
Symptom
Washer-dryer stops mid-cycle and the door remains locked, but no error code is displayed.
Program Interruption / Control Hang
Symptom
Washer-dryer trips the household circuit breaker or RCD during operation.
Electrical Short / Earth Leakage
Symptom
Water leaking from the bottom rear or underneath the washer-dryer.
Internal Hose / Pump / Tub Leak
Symptom
Water leaking from the front of the washer-dryer, often around the door area.
Door Seal (Gasket) Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Washer-dryer will not fill with water, cycle stops shortly after start and E1 is displayed.
|
Water Inlet Timeout / No Fill | View Details |
| E10 |
Washer-dryer shows E10 and will not start or stops; often related to water inlet or level issues.
|
General Water Supply / Level Error | View Details |
| E11 |
Washer-dryer displays E11; machine may stop with water inside or fail to progress.
|
Drain / Pump Feedback Error | View Details |
| E2 |
Washer-dryer does not drain water, drum remains full and E2 is displayed.
|
Drain Pump Failure / Drain Timeout | View Details |
| E21 |
Washer-dryer shows E21 and will not spin or wash; drum does not rotate.
|
Motor Drive Error | View Details |
| E22 |
Washer-dryer displays E22; may be associated with door not unlocking at end of cycle.
|
Door Unlock Error | View Details |
| E3 |
Washer-dryer overfills or shows E3 shortly after filling, sometimes with water visible in the door seal.
|
Water Level Sensor / Pressure Switch Error | View Details |
| E30 |
Washer-dryer shows E30 and stops; often accompanied by water in the base tray or continuous drain pump operation.
|
Leak / Overflow Protection Activated | View Details |
| E31 |
Washer-dryer displays E31; may be related to drying performance or condenser system.
|
Condenser / Drying System Error | View Details |
| E4 |
Washer-dryer displays E4 and stops, often during spin; machine may be heavily shaking or load is off-balance.
|
Unbalanced Load / Motor Speed Detection Error | View Details |
| E40 |
Washer-dryer shows E40; door symbol may flash and cycle will not start.
|
Door Not Properly Closed | View Details |
| E41 |
Washer-dryer displays E41; door appears closed but machine still reports door error.
|
Door Lock Signal Error | View Details |
| E5 |
Washer-dryer does not heat water during wash; clothes come out cold and E5 is displayed.
|
Wash Heating Circuit Failure | View Details |
| E50 |
Washer-dryer shows E50; drum may not turn or may stop suddenly during cycle.
|
General Motor Error | View Details |
| E51 |
Washer-dryer displays E51; often appears immediately when trying to start a cycle.
|
Motor Triac Short / Motor Drive Short Circuit | View Details |
| E6 |
Drying function does not heat; laundry remains wet and cold after drying cycle, E6 appears.
|
Dryer Heating Circuit Failure | View Details |
| E60 |
Washer-dryer shows E60; drying or washing heating may be affected.
|
General Heating System Error | View Details |
| E61 |
Washer-dryer displays E61; wash water does not reach set temperature in time.
|
Insufficient Wash Heating | View Details |
| E62 |
Washer-dryer shows E62; water overheats or there is a risk of boiling.
|
Overheating / Heater Stuck On | View Details |
| E7 |
Washer-dryer displays E7 and will not start or stops mid-cycle; door may remain locked.
|
Door Lock / Interlock Failure | View Details |
| E70 |
Washer-dryer displays E70; temperature readings appear erratic or absent.
|
NTC Sensor Circuit Open/Short | View Details |
| E8 |
Washer-dryer shows E8 and stops; often associated with motor not turning or erratic drum movement.
|
Motor / Tachometer Feedback Error | View Details |
| E9 |
Washer-dryer displays E9 and stops; may be associated with overheating or unusual temperature behavior.
|
Temperature Sensor (NTC) Error | View Details |
| E90 |
Washer-dryer shows E90; machine may be unresponsive or stuck.
|
Communication / Configuration Error | View Details |
| – |
Detergent remains in the drawer after the wash; water overflows from the detergent compartment.
|
Detergent Drawer / Dispenser Blockage | View Details |
| – |
Drying cycle takes excessively long and clothes remain damp, even though no error code is shown.
|
Poor Drying Performance / Airflow Restriction | View Details |
| – |
Washer-dryer displays incorrect time remaining or cycles end much sooner/longer than expected.
|
Program Timing / Sensor Feedback Issue | View Details |
| – |
Washer-dryer does not power on at all; no lights or display, no response to buttons.
|
No Power / Dead Appliance | View Details |
| – |
Washer-dryer door glass becomes extremely hot during drying, more than usual.
|
Excessive Drying Temperature / Airflow Restriction | View Details |
| – |
Washer-dryer drum does not turn during wash or dry, but you can hear humming or water filling.
|
Drum Not Turning / Drive Failure | View Details |
| – |
Washer-dryer emits a burning smell or hot plastic odor during operation.
|
Overheating / Electrical or Mechanical Friction | View Details |
| – |
Washer-dryer fills and washes but will not spin; clothes remain very wet at end of cycle.
|
No Spin / Spin Inhibition | View Details |
| – |
Washer-dryer is very noisy during spin; loud rumbling or grinding sound from rear of machine.
|
Drum Bearing Wear / Failure | View Details |
| – |
Washer-dryer leaves visible detergent or white streaks on clothes after washing.
|
Poor Rinsing / Detergent Residue | View Details |
| – |
Washer-dryer makes a loud banging or knocking noise during spin; machine may move or "walk".
|
Excessive Vibration / Suspension Fault | View Details |
| – |
Washer-dryer powers on but will not start any program; Start button unresponsive or program cancels immediately.
|
User Interface / Control Lock or Program Start Inhibition | View Details |
| – |
Washer-dryer produces a musty or moldy smell; clothes smell unpleasant after washing or drying.
|
Biofilm / Mold Build-up in Drum and Hoses | View Details |
| – |
Washer-dryer stops mid-cycle and the door remains locked, but no error code is displayed.
|
Program Interruption / Control Hang | View Details |
| – |
Washer-dryer trips the household circuit breaker or RCD during operation.
|
Electrical Short / Earth Leakage | View Details |
| – |
Water leaking from the bottom rear or underneath the washer-dryer.
|
Internal Hose / Pump / Tub Leak | View Details |
| – |
Water leaking from the front of the washer-dryer, often around the door area.
|
Door Seal (Gasket) Leak | View Details |
No matching codes found
Advertisements