Fagor Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer will not start a cycle; display shows E01 and door symbol may flash.
Door Lock Failure
E02
Washer-dryer does not fill with water or fills very slowly; E02 appears on the display.
Water Inlet Timeout / Fill Error
E03
Washer-dryer does not drain water; cycle stops with water in drum and E03 displayed.
Drain Pump Timeout / Drain Error
E04
Washer-dryer overfills or shows E04 shortly after starting; may attempt to drain immediately.
Overfill / Water Level Sensor Error
E05
Washer-dryer does not heat water during wash; cycles may be extended and E05 appears.
Wash Heating Circuit Failure
E06
Drying function does not heat; clothes remain wet and cool; E06 displayed during or after drying.
Dryer Heating Circuit Failure
E07
Washer-dryer drum does not rotate during wash or spin; E07 appears on the display.
Motor Drive Fault
E08
Washer-dryer fails to reach or maintain spin speed; E08 displayed during spin phase.
Tachometer / Speed Feedback Error
E09
Washer-dryer trips the household breaker or shows E09; may not power up correctly.
Heater Earth Leakage / Short Circuit
E10
Washer-dryer stops mid-cycle with E10; often related to water level not detected correctly.
Water Level Detection Fault
E11
Washer-dryer door will not unlock at end of cycle; E11 may be displayed.
Door Unlock Failure
E12
Washer-dryer shows E12 and may stop during drying; often accompanied by poor drying performance.
Dryer Airflow / Condenser Blockage
E13
Washer-dryer displays E13 and may stop; often associated with water detected in base tray.
Leak / Anti-Flood System Activated
E14
Washer-dryer shows E14 and may not start or may stop unexpectedly; often related to NTC sensor issues.
Temperature Sensor (NTC) Fault
E15
Washer-dryer does not spin; E15 displayed; drum may tumble but not reach high speed.
Unbalanced Load / Spin Protection Fault
E16
Washer-dryer shows E16 and may not start; often associated with communication issues between boards.
Communication Error (Main PCB to Interface)
E17
Washer-dryer shows E17 and does not start; often related to door not detected as closed.
Door Status Detection Error
E18
Washer-dryer shows E18 and may stop; often associated with drain time exceeding limit.
Extended Drain Time / Partial Blockage
E19
Washer-dryer shows E19; may be related to drying water circuit (for condenser type).
Dryer Condenser Water Circuit Fault
E20
Washer-dryer shows E20 and may not heat in drying; often linked to overheating protection.
Dryer Overheat Protection Activated
Symptom
Drying cycle runs but clothes come out damp or take very long to dry.
Poor Drying Performance
Symptom
Drying cycle stops prematurely and laundry is still wet.
Moisture Sensing / Control Issue
Symptom
Washer-dryer combo will not power on at all; no lights or display.
No Power / Dead Appliance
Symptom
Washer-dryer display and lights flicker or reset during operation.
Intermittent Power / Electrical Noise
Symptom
Washer-dryer door will not open at end of cycle, but no error code is displayed.
Door Stuck / Lock Not Releasing
Symptom
Washer-dryer emits a strong mouldy or musty odour from the drum.
Biofilm / Mould Build-Up
Symptom
Washer-dryer fills and drains but drum does not turn during wash or spin; no error code shown.
Drum Not Turning / Motor Not Running
Symptom
Washer-dryer is very noisy during spin; banging or rumbling sounds from drum area.
Drum Bearing or Suspension Failure
Symptom
Washer-dryer leaves clothes very wet at the end of the cycle; spin seems weak or incomplete.
Poor Spin Performance
Symptom
Washer-dryer leaves detergent or fabric softener in the drawer at the end of the cycle.
Poor Dispenser Flushing
Symptom
Washer-dryer makes a scraping or metallic noise when the drum turns.
Foreign Object Between Drum and Tub
Symptom
Washer-dryer produces a burning smell during wash or spin.
Overheating Motor or Belt Slippage
Symptom
Washer-dryer produces a loud high-pitched squeal during spin.
Pulley or Belt Noise
Symptom
Washer-dryer stops mid-cycle without draining or spinning; no error code shown.
Cycle Interruption / Control Logic Fault
Symptom
Washer-dryer takes much longer than the displayed time to complete cycles.
Extended Cycle Time / Auto-Adjustment
Symptom
Washer-dryer vibrates excessively or "walks" across the floor during spin.
Excessive Vibration / Poor Balancing
Symptom
Water leaking from the front of the washer-dryer, often around the door area.
Door Seal (Gasket) Leak
Symptom
Water leaking from the rear or bottom of the washer-dryer during wash or spin.
Internal Hose or Pump Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer will not start a cycle; display shows E01 and door symbol may flash.
|
Door Lock Failure | View Details |
| E02 |
Washer-dryer does not fill with water or fills very slowly; E02 appears on the display.
|
Water Inlet Timeout / Fill Error | View Details |
| E03 |
Washer-dryer does not drain water; cycle stops with water in drum and E03 displayed.
|
Drain Pump Timeout / Drain Error | View Details |
| E04 |
Washer-dryer overfills or shows E04 shortly after starting; may attempt to drain immediately.
|
Overfill / Water Level Sensor Error | View Details |
| E05 |
Washer-dryer does not heat water during wash; cycles may be extended and E05 appears.
|
Wash Heating Circuit Failure | View Details |
| E06 |
Drying function does not heat; clothes remain wet and cool; E06 displayed during or after drying.
|
Dryer Heating Circuit Failure | View Details |
| E07 |
Washer-dryer drum does not rotate during wash or spin; E07 appears on the display.
|
Motor Drive Fault | View Details |
| E08 |
Washer-dryer fails to reach or maintain spin speed; E08 displayed during spin phase.
|
Tachometer / Speed Feedback Error | View Details |
| E09 |
Washer-dryer trips the household breaker or shows E09; may not power up correctly.
|
Heater Earth Leakage / Short Circuit | View Details |
| E10 |
Washer-dryer stops mid-cycle with E10; often related to water level not detected correctly.
|
Water Level Detection Fault | View Details |
| E11 |
Washer-dryer door will not unlock at end of cycle; E11 may be displayed.
|
Door Unlock Failure | View Details |
| E12 |
Washer-dryer shows E12 and may stop during drying; often accompanied by poor drying performance.
|
Dryer Airflow / Condenser Blockage | View Details |
| E13 |
Washer-dryer displays E13 and may stop; often associated with water detected in base tray.
|
Leak / Anti-Flood System Activated | View Details |
| E14 |
Washer-dryer shows E14 and may not start or may stop unexpectedly; often related to NTC sensor issues.
|
Temperature Sensor (NTC) Fault | View Details |
| E15 |
Washer-dryer does not spin; E15 displayed; drum may tumble but not reach high speed.
|
Unbalanced Load / Spin Protection Fault | View Details |
| E16 |
Washer-dryer shows E16 and may not start; often associated with communication issues between boards.
|
Communication Error (Main PCB to Interface) | View Details |
| E17 |
Washer-dryer shows E17 and does not start; often related to door not detected as closed.
|
Door Status Detection Error | View Details |
| E18 |
Washer-dryer shows E18 and may stop; often associated with drain time exceeding limit.
|
Extended Drain Time / Partial Blockage | View Details |
| E19 |
Washer-dryer shows E19; may be related to drying water circuit (for condenser type).
|
Dryer Condenser Water Circuit Fault | View Details |
| E20 |
Washer-dryer shows E20 and may not heat in drying; often linked to overheating protection.
|
Dryer Overheat Protection Activated | View Details |
| – |
Drying cycle runs but clothes come out damp or take very long to dry.
|
Poor Drying Performance | View Details |
| – |
Drying cycle stops prematurely and laundry is still wet.
|
Moisture Sensing / Control Issue | View Details |
| – |
Washer-dryer combo will not power on at all; no lights or display.
|
No Power / Dead Appliance | View Details |
| – |
Washer-dryer display and lights flicker or reset during operation.
|
Intermittent Power / Electrical Noise | View Details |
| – |
Washer-dryer door will not open at end of cycle, but no error code is displayed.
|
Door Stuck / Lock Not Releasing | View Details |
| – |
Washer-dryer emits a strong mouldy or musty odour from the drum.
|
Biofilm / Mould Build-Up | View Details |
| – |
Washer-dryer fills and drains but drum does not turn during wash or spin; no error code shown.
|
Drum Not Turning / Motor Not Running | View Details |
| – |
Washer-dryer is very noisy during spin; banging or rumbling sounds from drum area.
|
Drum Bearing or Suspension Failure | View Details |
| – |
Washer-dryer leaves clothes very wet at the end of the cycle; spin seems weak or incomplete.
|
Poor Spin Performance | View Details |
| – |
Washer-dryer leaves detergent or fabric softener in the drawer at the end of the cycle.
|
Poor Dispenser Flushing | View Details |
| – |
Washer-dryer makes a scraping or metallic noise when the drum turns.
|
Foreign Object Between Drum and Tub | View Details |
| – |
Washer-dryer produces a burning smell during wash or spin.
|
Overheating Motor or Belt Slippage | View Details |
| – |
Washer-dryer produces a loud high-pitched squeal during spin.
|
Pulley or Belt Noise | View Details |
| – |
Washer-dryer stops mid-cycle without draining or spinning; no error code shown.
|
Cycle Interruption / Control Logic Fault | View Details |
| – |
Washer-dryer takes much longer than the displayed time to complete cycles.
|
Extended Cycle Time / Auto-Adjustment | View Details |
| – |
Washer-dryer vibrates excessively or "walks" across the floor during spin.
|
Excessive Vibration / Poor Balancing | View Details |
| – |
Water leaking from the front of the washer-dryer, often around the door area.
|
Door Seal (Gasket) Leak | View Details |
| – |
Water leaking from the rear or bottom of the washer-dryer during wash or spin.
|
Internal Hose or Pump Leak | View Details |
No matching codes found
Advertisements