GE Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer combo displays E01 and will not start; often indicates a generic control fault.
General Control Error / Software Fault
E02
Washer-dryer combo shows E02 and may not start or may stop shortly after filling.
Motor Start / Drive Initialization Error
E03
Washer-dryer combo displays E03 and stops with water in the drum; may be similar to a drain error.
Drain Time Exceeded / Pump Performance Error
E04
Washer-dryer combo shows E04 and may overfill or leak from the door.
Overfill / Overflow Error
E05
Washer-dryer combo displays E05 and may not heat water during wash cycles.
Wash Heater / Temperature Sensor Error (if equipped with internal water heater)
E06
Washer-dryer combo shows E06 and may not lock the door or may unlock unexpectedly.
Door Unlock / Lock Timing Error
E07
Washer-dryer combo displays E07 and may not spin or may stop with an unbalanced load.
Unbalance Detection / Spin Abort Error
E08
Washer-dryer combo shows E08 and may not tumble or spin; motor may hum briefly.
Motor Overcurrent / Overload Error
E09
Washer-dryer combo displays E09 and may stop mid-cycle with no obvious mechanical issue.
Voltage / Power Supply Error
E22
Washer-dryer combo stops mid-cycle and displays E22; may not advance to rinse or spin.
Water Inlet Timeout / Fill Error
E23
Washer-dryer combo displays E23 and will not drain; water remains in drum.
Drain Pump Error / Drain Timeout
E24
Washer-dryer combo shows E24 and may stop with water in the tub or fail to start spin.
Drain Pump Circuit / Wiring Fault
E31
Washer-dryer combo displays E31 and will not start or stops shortly after starting wash.
Door Lock / Door Switch Error
E32
Washer-dryer combo shows E32 and will not start spin or wash; door may remain locked.
Door Lock Circuit / Communication Fault
E42
Washer-dryer combo displays E42 and will not spin; drum may not turn at all.
Motor Drive Error / Motor Not Turning
E43
Washer-dryer combo shows E43 and may tumble but not reach full spin speed.
Motor Tachometer / Speed Sensor Error
E51
Washer-dryer combo displays E51 and will not heat during drying cycle; clothes remain wet and cold.
Dryer Heater Circuit Error
E52
Washer-dryer combo shows E52; dryer cycle may start but shut off quickly or never heat properly.
Dryer Temperature Sensor / Thermistor Error
E61
Washer-dryer combo displays E61 and will not start; control panel may be unresponsive or freeze.
Main Control Board Communication / Internal Fault
E62
Washer-dryer combo shows E62; display may flicker or some buttons do not respond.
User Interface / Display Board Error
E71
Washer-dryer combo displays E71 and may overfill, underfill, or stop unexpectedly during wash.
Water Level / Pressure Sensor Error
E72
Washer-dryer combo shows E72; unit may not detect water level correctly and can abort cycles.
Water Level Sensor Calibration / Range Error
E81
Washer-dryer combo displays E81 and may stop heating during wash or dry; can be associated with overheating.
Overtemperature / Overheat Protection Error
E82
Washer-dryer combo shows E82 and may shut down unexpectedly or trip internal thermal protection.
Internal Electronics Overheat / Control Board Overtemperature
E91
Washer-dryer combo displays E91 and may not start; communication between boards is lost.
Communication Error Between Main Control and Motor/Interface Board
E92
Washer-dryer combo shows E92; display may be blank or show garbled characters.
Display Communication / UI to Main Board Error
Symptom
Washer-dryer combo door will not unlock at the end of the cycle; clothes are trapped inside.
Door Stuck Locked
Symptom
Washer-dryer combo drum does not turn during drying, but heater works; clothes get hot but do not tumble.
No Tumble in Dry Cycle
Symptom
Washer-dryer combo dryer runs but produces no heat at all; clothes stay cold.
No Heat in Dryer
Symptom
Washer-dryer combo emits a burning smell during drying or spinning.
Overheating / Friction or Electrical Burning
Symptom
Washer-dryer combo fills with water but will not agitate or tumble during wash.
No Wash Agitation / Tumble
Symptom
Washer-dryer combo has a strong musty or moldy odor inside the drum.
Biofilm / Mold Growth in Tub and Gasket
Symptom
Washer-dryer combo has power but will not start any cycle; start button does nothing.
No Start / Control Lock or Input Fault
Symptom
Washer-dryer combo intermittently shuts off mid-cycle and then restarts or remains off until cooled.
Thermal Overload / Motor or Control Overheating
Symptom
Washer-dryer combo is very noisy during spin; loud rumbling or roaring sound.
Tub Bearing Failure
Symptom
Washer-dryer combo leaks water from the front door area during wash.
Door Gasket / Boot Leak
Symptom
Washer-dryer combo leaks water from underneath or the rear during operation.
Internal Hose or Tub Seal Leak
Symptom
Washer-dryer combo leaves clothes very wet after drying; dryer runs but does not heat well.
Poor Drying Performance / Restricted Airflow
Symptom
Washer-dryer combo leaves detergent or fabric softener residue on clothes after wash.
Poor Rinsing / Dispenser Performance Issue
Symptom
Washer-dryer combo makes a high-pitched squealing or screeching noise when tumbling or spinning.
Worn Belt or Support Rollers / Idler Pulley Noise
Symptom
Washer-dryer combo makes loud banging or knocking noises during spin; unit may move or walk.
Excessive Vibration / Out-of-Balance Spin
Symptom
Washer-dryer combo will not power on at all; no lights or display.
No Power / Dead Unit
Symptom
Washer-dryer combo will not spin; clothes come out soaking wet after cycle.
No Spin / Spin Abort
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer combo displays E01 and will not start; often indicates a generic control fault.
|
General Control Error / Software Fault | View Details |
| E02 |
Washer-dryer combo shows E02 and may not start or may stop shortly after filling.
|
Motor Start / Drive Initialization Error | View Details |
| E03 |
Washer-dryer combo displays E03 and stops with water in the drum; may be similar to a drain error.
|
Drain Time Exceeded / Pump Performance Error | View Details |
| E04 |
Washer-dryer combo shows E04 and may overfill or leak from the door.
|
Overfill / Overflow Error | View Details |
| E05 |
Washer-dryer combo displays E05 and may not heat water during wash cycles.
|
Wash Heater / Temperature Sensor Error (if equipped with internal water heater) | View Details |
| E06 |
Washer-dryer combo shows E06 and may not lock the door or may unlock unexpectedly.
|
Door Unlock / Lock Timing Error | View Details |
| E07 |
Washer-dryer combo displays E07 and may not spin or may stop with an unbalanced load.
|
Unbalance Detection / Spin Abort Error | View Details |
| E08 |
Washer-dryer combo shows E08 and may not tumble or spin; motor may hum briefly.
|
Motor Overcurrent / Overload Error | View Details |
| E09 |
Washer-dryer combo displays E09 and may stop mid-cycle with no obvious mechanical issue.
|
Voltage / Power Supply Error | View Details |
| E22 |
Washer-dryer combo stops mid-cycle and displays E22; may not advance to rinse or spin.
|
Water Inlet Timeout / Fill Error | View Details |
| E23 |
Washer-dryer combo displays E23 and will not drain; water remains in drum.
|
Drain Pump Error / Drain Timeout | View Details |
| E24 |
Washer-dryer combo shows E24 and may stop with water in the tub or fail to start spin.
|
Drain Pump Circuit / Wiring Fault | View Details |
| E31 |
Washer-dryer combo displays E31 and will not start or stops shortly after starting wash.
|
Door Lock / Door Switch Error | View Details |
| E32 |
Washer-dryer combo shows E32 and will not start spin or wash; door may remain locked.
|
Door Lock Circuit / Communication Fault | View Details |
| E42 |
Washer-dryer combo displays E42 and will not spin; drum may not turn at all.
|
Motor Drive Error / Motor Not Turning | View Details |
| E43 |
Washer-dryer combo shows E43 and may tumble but not reach full spin speed.
|
Motor Tachometer / Speed Sensor Error | View Details |
| E51 |
Washer-dryer combo displays E51 and will not heat during drying cycle; clothes remain wet and cold.
|
Dryer Heater Circuit Error | View Details |
| E52 |
Washer-dryer combo shows E52; dryer cycle may start but shut off quickly or never heat properly.
|
Dryer Temperature Sensor / Thermistor Error | View Details |
| E61 |
Washer-dryer combo displays E61 and will not start; control panel may be unresponsive or freeze.
|
Main Control Board Communication / Internal Fault | View Details |
| E62 |
Washer-dryer combo shows E62; display may flicker or some buttons do not respond.
|
User Interface / Display Board Error | View Details |
| E71 |
Washer-dryer combo displays E71 and may overfill, underfill, or stop unexpectedly during wash.
|
Water Level / Pressure Sensor Error | View Details |
| E72 |
Washer-dryer combo shows E72; unit may not detect water level correctly and can abort cycles.
|
Water Level Sensor Calibration / Range Error | View Details |
| E81 |
Washer-dryer combo displays E81 and may stop heating during wash or dry; can be associated with overheating.
|
Overtemperature / Overheat Protection Error | View Details |
| E82 |
Washer-dryer combo shows E82 and may shut down unexpectedly or trip internal thermal protection.
|
Internal Electronics Overheat / Control Board Overtemperature | View Details |
| E91 |
Washer-dryer combo displays E91 and may not start; communication between boards is lost.
|
Communication Error Between Main Control and Motor/Interface Board | View Details |
| E92 |
Washer-dryer combo shows E92; display may be blank or show garbled characters.
|
Display Communication / UI to Main Board Error | View Details |
| – |
Washer-dryer combo door will not unlock at the end of the cycle; clothes are trapped inside.
|
Door Stuck Locked | View Details |
| – |
Washer-dryer combo drum does not turn during drying, but heater works; clothes get hot but do not tumble.
|
No Tumble in Dry Cycle | View Details |
| – |
Washer-dryer combo dryer runs but produces no heat at all; clothes stay cold.
|
No Heat in Dryer | View Details |
| – |
Washer-dryer combo emits a burning smell during drying or spinning.
|
Overheating / Friction or Electrical Burning | View Details |
| – |
Washer-dryer combo fills with water but will not agitate or tumble during wash.
|
No Wash Agitation / Tumble | View Details |
| – |
Washer-dryer combo has a strong musty or moldy odor inside the drum.
|
Biofilm / Mold Growth in Tub and Gasket | View Details |
| – |
Washer-dryer combo has power but will not start any cycle; start button does nothing.
|
No Start / Control Lock or Input Fault | View Details |
| – |
Washer-dryer combo intermittently shuts off mid-cycle and then restarts or remains off until cooled.
|
Thermal Overload / Motor or Control Overheating | View Details |
| – |
Washer-dryer combo is very noisy during spin; loud rumbling or roaring sound.
|
Tub Bearing Failure | View Details |
| – |
Washer-dryer combo leaks water from the front door area during wash.
|
Door Gasket / Boot Leak | View Details |
| – |
Washer-dryer combo leaks water from underneath or the rear during operation.
|
Internal Hose or Tub Seal Leak | View Details |
| – |
Washer-dryer combo leaves clothes very wet after drying; dryer runs but does not heat well.
|
Poor Drying Performance / Restricted Airflow | View Details |
| – |
Washer-dryer combo leaves detergent or fabric softener residue on clothes after wash.
|
Poor Rinsing / Dispenser Performance Issue | View Details |
| – |
Washer-dryer combo makes a high-pitched squealing or screeching noise when tumbling or spinning.
|
Worn Belt or Support Rollers / Idler Pulley Noise | View Details |
| – |
Washer-dryer combo makes loud banging or knocking noises during spin; unit may move or walk.
|
Excessive Vibration / Out-of-Balance Spin | View Details |
| – |
Washer-dryer combo will not power on at all; no lights or display.
|
No Power / Dead Unit | View Details |
| – |
Washer-dryer combo will not spin; clothes come out soaking wet after cycle.
|
No Spin / Spin Abort | View Details |
No matching codes found
Advertisements